What is a booster hose reel?
Booster Hose (aka Red Line) is a rubber-covered, thick-walled, flexible hose used to fight small fires. It retains its round cross-section when it is not under pressure and is usually carried on a reel on the fire truck, rather than being stored flat.
What is diameter of a booster line?
between ¾ and 1 ½ inches
Booster: A Booster is a traditional hard rubber hose typically between ¾ and 1 ½ inches in diameter. main use for Booster Fire Hose: A Booster is typically used for small fires or small brush fires. Hard Suction: Hard suction is a stiff fold up that is typically 10-15 ft.
What is a booster line firefighting?
Booster line is a hose that is usually one inch in diameter and rubber jacketed. They are used on small fires using the water carried in an apparatus’ booster tank and are usually stored on reels. Also referred to as a red line.
How long should a hose reel be?
The length of fire hoses often varies, but standard hose reels have a maximum extension length of 118 feet (36 meters). A hose reel with a diameter of between 0.5 inches (13mm) to 0.75 inches (19mm) should accommodate 11 ounces (0.33 liters) of water in a fire fighting situation.
How much does a booster line flow?
The limited fire flow from a booster line, generally around 50 to 60 gpm, was usually sufficient for a small fire.
What is single jacket hose?
A single jacket fire hose has one woven polyester jacket glued to the outside of the rubber liner. A single jacket can protect the rubber liner only if the hose is being used for occasionally light use, a temporary job or on a non-abrasive surface such as grass. Single jacket hose can save cost in the right situation.
How much PSI comes out of a fire hose?
The usual working pressure of a firehose can vary between 8 and 20 bar (800 and 2,000 kPa; 116 and 290 psi) while per the NFPA 1961 Fire Hose Standard, its bursting pressure is in excess of 110 bar. (11,000kPa; 1600psi) Hose is one of the basic, essential pieces of fire-fighting equipment.
What do you pump a booster line at?
When to pull it The limited fire flow from a booster line, generally around 50 to 60 gpm, was usually sufficient for a small fire.
How do fire boosters work?
The drop in water pressure is detected by a pressure switch which in turn starts the booster pump(s), drawing water from the water supply to increase the water pressure of the system. Water from the hydrant is then directed through the layflat fire hose to a nozzle which is then directed to the seat of a fire.
What must not be done when using the hose reel?
Hose Reels are suitable for Class A fires: Paper, Textiles, Wood, Most Plastics and Rubber. Do NOT use on electrical fires, remember water conducts electricity, so using a fire hose reel on it could lead to electrocution!