What happens when power shift PTO is disengaged?
When the power shift PTO is disengaged, the solenoid de-energizes. Air or hydraulic fluid deadheads against the valve. From there, air is released to atmosphere through a valve, and hydraulic fluid exhausts into the PTO. Here are some breakdowns of the potential causes and solutions for troubleshooting the PTO.
What does the SGA do on a Freightliner truck?
SGA provides assistance when turning right and moving into the right-hand lane. A warning lamp activates to inform the driver that an object has been detected in the monitored area. A warning tone also sounds if there is a risk of collision. SGA is not active while reversing.
How is air released from a power shift PTO?
From there, air is released to atmosphere through a valve, and hydraulic fluid exhausts into the PTO. Here are some breakdowns of the potential causes and solutions for troubleshooting the PTO. It is first important to understand that many problems from a Power Shift PTO are the result of incorrect plumbing.
What happens when PTO is in overspeed protection mode?
When the PTO is in overspeed protection mode, audio and visual blinking overspeed warning alerts the operator. This system can be used in applications including LP Gas Trucks, Water Trucks, Fire and Rescue, Aerial Devices, Dump Truck & Trailers, Snow and Ice Removal.
How to fix no crank on Chevy C5500?
The TCM is manufactured so that the heatsink of the TCM is isolated from all vehicle electrical systems including vehicle chassis ground.Do not ground welders,battery chargers,electrostatic painters or any other equipment to the heatsink.Disconnect the 80 way connector from the TCM when electrically welding etc. to the vehicle. 1.
Can a 2006 Chevy C5500 start without a key?
I have a 2006 Chevy C5500 with the duramax. Its a bus and I am going to turn it into a dump truck….hopefully. My issue as i said is no crank no start from the key. I was able to get it started by turning the key on and crossing a screwdriver over the terminals on the starter but I am not able to start it with the key.
How can I jump start my Chevy C5500?
1. Battery positive wires to touch the heatsink of the TCM [e.g.When jump starting vehicle] 2. Positive battery power chassis harness wire to pin 10 and pin 70 of the TCM to be wired without fuse protection of 10-15 amps. 3. Physical contact between heatsink and vehicle chassis or other ground circuit points.