What happens if your engine control unit fails?
The worst thing that could happen because of a failed ECU is to have a car that won’t start. At first, you might notice it becomes more difficult to crank over until it eventually stops. While having a non-running car can mean many things, it’s also a symptom that the engine control unit has failed completely.
What causes a car to not start after filling up?
Bad fuel pump: A faulty fuel pump won’t deliver fuel to the engine, even if you’ve just filled up. Bad spark plugs: Without hot sparks to ignite the fuel charge in each cylinder, there is no combustion and no expansion of the burning mixture. Thus, the engine will not start.
Can a PCM be installed in the same car?
Many PCMs appear to be exactly the same on the outside (same sized box and connectors) but may be wired or calibrated differently inside. If the wrong PCM is installed in a vehicle, it may run but probably won’t run well. Close enough isn’t good enough when it comes to replacing PCMs. It must be the correct replacement for the application.
Can a bad ECM cause a car to not start?
Of course, there are other reasons a car may not start, including a bad starter or a blown alternator. If you’ve replaced these parts and your car won’t start, your ECM is the most likely cause. Once again, you’ll need to take your car to a mechanic to be sure.
What to do when your car won’t start?
Try: Cycling the Key If your car turns on but won’t start, turn on the dome light and watch it while you try to start the engine. If the light goes out, it’s a sign the battery is really weak—almost dead. To heat up the battery, terminals and starter, try the “key cycling” trick.
What should I do if my Mercedes Benz won’t start?
Start the car and you should be able to get around 60 psi. When the engine is running and when you turn off the engine the pressure should stay steady. Always perform this test on a cold engine. Next, make sure that the fuel injector connections are secure and not loose. Check the fuel pump and the fuel pump relay.
What causes a car to not start at the base?
1 Faulty Starter motor 2 Low voltage/Bad car battery 3 Bad Fuel pump 4 Faulty Crankshaft Sensor 5 Faulty Ignition coil 6 Faulty Ignition Switch 7 Faulty Ignition Relay / Main Relay
Why does my car not start when I plug it in?
If the starting, charging and fuel systems are working, the problem could be inside the engine. A broken timing belt, timing chain or timing gear means you can crank the engine until you drain the battery, and it still won’t start.