What happens if you have an OBD code p0125 problem?

What happens if you have an OBD code p0125 problem?

The OBD-II scanner error code P0125 problem probably won’t cause any drivability problems, but the check engine light will light up. You’ll probably experience bad fuel economy or have a poor heater performance. The biggest symptom you may notice is if the car overheats.

What are the symptoms of a bad valve cover gasket?

Oil collects dirt and debris under the hood and will appear to be “caked” on the valve cover or cylinder head. If you have the oil changed, or look under your hood and discover that the valve cover is dirty, it’s most likely caused by a bad valve cover gasket. 3. Engine is low on oil As oil leaks from the valve cover gasket, it leaves the oil pan.

How can I tell if my oil change valve cover is bad?

During most oil changes, the technician will inspect the valve cover to see if there is any leaking oil coming from the valve cover gasket. The quickest indication of this problem is when the valve cover/cylinder head is very dirty. Oil collects dirt and debris under the hood and will appear to be “caked” on the valve cover or cylinder head.

Where is the right bank valve cover gasket?

The most difficult and timing consuming part of that job is getting to and removing the right bank valve cover gasket. The right bank is up against the firewall and is covered by both a wire harness and the intake plenum.

What does the p1135 code on a Toyota mean?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P1135 TOYOTA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

What does the ECT mean on a Lexus p0125?

The ECT is 0u0002C (32u0002F) at engine start. After 5 minutes running time, the ECT sensor still indicates that the engine is not warm enough to begin active feedback control of the air-fuel ratio. The ECM interprets this as a fault in the sensor or cooling system and sets a DTC.