What happens if someone breaks my car window?
Report the incident to the police. Cancel credit cards, deactivate your phone and place a fraud alert (if valuables were left in the car) File an insurance claim. Replace your car window.
Why does my Mitsubishi 380 window not go up?
The R/H/R window in my 380 wont go up i took the door trim of and could see that there is a problem with electric winding setup. Mitsubishi Mechanic: Doug, ASE Certified Technician replied 9 years ago
Why is my driver side window not working?
Driver side window will not go down or up. i can hear it working but no movement from the window. The window was down half way and would not go up or down. Was able to pull it up and it stayed but wil…
How to replace electric window regulator for Mitsubishi 380?
Customerreply replied 9 years ago The R/H/R window in my 380 wont go up i took the door trim of and could see that there is a problem with electric winding setup. Mitsubishi Mechanic: Doug, ASE Certified Technician replied 9 years ago
The R/H/R window in my 380 wont go up i took the door trim of and could see that there is a problem with electric winding setup. Mitsubishi Mechanic: Doug, ASE Certified Technician replied 9 years ago
How do I remove front the Door liner from a Mitsubishi 380?
Tilt the door panel outward then lift it up off the door. Note that the front inside window seal can sometimes stay on the door liner and other times the door it will stick to the door frame. This is not a problem if it stays on the door frame, the liner can be slide back into the seal without too much effort.
Customerreply replied 9 years ago The R/H/R window in my 380 wont go up i took the door trim of and could see that there is a problem with electric winding setup. Mitsubishi Mechanic: Doug, ASE Certified Technician replied 9 years ago
How do you remove front door trim on a Mitsubishi?
The trim can be a bit of a bugger to get out; you will need to use the flat edge screw driver inserted between the trim and the lock rocker at the rear/pivot end, then pry down to release the clip. Then insert it in the same location but at the bottom between the trim and the handle release and push upward to release that clip.