What does valet switch do?
The valet switch is used for turning the valet mode on and off. Valet mode prevents the security system from arming, yet allows the convenience functions (door lock & unlock, etc.) to operate normally. Valet mode is useful when valet parking, fueling or servicing your vehicle.
What is the valet push button switch?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.
Why is it called a valet key?
A valet key is essentially a spare key that comes with a vehicle but there are some varieties to the valet key. Brands like BMW and Audi feature valet keys. The valet key will open the car door and start the car but will prevent someone from unlocking the glove box or the trunk.
How do I stop valet mode?
How to Exit Valet Mode
- Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine.
- Press and release the LOCK and TRUNK buttons (I & III) simultaneously.
- Remove the key from the ignition and attempt to remote start your vehicle.
Where’s is the valet switch?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing. Behind a fuse block door or access panel. Low in the center console in the back of a pocket. Along side of the fuse block.
What is the valet button?
The valet button is to the right of the steering column and is quite a large button and has the words ‘VALET’ clearly written on it. I think it allows you to lock valuables in the glove box but allow a Valet or Service engineer to drive the car – they will not be able to get into the glove box.
What is valet mode?
What is “Valet Mode”? Valet mode is a setting in Compustar and Arctic Start systems that will shut down the alarm system and the remote starter. It will only allow the remotes to retain key-less entry to be used to lock and unlock the doors.