What does the red light on my Harley mean?
With the Ignition switch off, put the bike into the “run” position, then turn on the ignition. This should put your bike into diagnostics mode. Use the “Trip” switch to cycle through the codes. anyway….that red light means check your codes!
Can a Dyna Super Glide crank but not start?
Discussion in ‘ Electrical ‘ started by 92chrisdyna, Aug 16, 2010 . 92 dyna super glide my bike cranks but wont start I have power to the coil and no spark I replaced the coil and nothing where do I go from here I am new to harleys and new to the forum and love some help from you guys thanks
What to do if your Harley Davidson won’t start?
Harley Davidson Won’t Start But Cranks HELP! – YouTube Harley Davidson Won’t Start But Cranks HELP! If playback doesn’t begin shortly, try restarting your device.
How to make a motorcycle crank but no start?
Grounding plugs to block wont give you a spark. youll have to make a set of dummy plugs by taping them together. turn spark plugs opposite of eachother, metal to metal and tape with electrical tape. Then plug the boots back on and check again. Click to expand… I don’t understand this at all.
What’s the voltage on a Harley Davidson starter?
I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.
Discussion in ‘ Electrical ‘ started by 92chrisdyna, Aug 16, 2010 . 92 dyna super glide my bike cranks but wont start I have power to the coil and no spark I replaced the coil and nothing where do I go from here I am new to harleys and new to the forum and love some help from you guys thanks
Why does my Harley Davidson crank but not start?
There have been a few reports of a P1009 code – incorrect password also. It appears the turn signal and stalls or cranks but will not start. Try removing the ecm and security fuses, wait ten minutes and reinstall the fuses. This “reboots” the turn signal module and the motorcycle will then start from that point on.
Why is my Harley Davidson Ultra Classic not starting?
I have a 2010 ultra classic with ABS. It is not starting. The battery voltage is 12.75 off the battery. When I turn the main switch on, I get a drop to 12.5, and when the kill switch is turned on, I get a drop to 12.38. The self test goes out and hit the start switch with nothing – no volt drop, no starter engage, no nothing. DEAD.
Why does my Harley Davidson have no spark?
If you have power to the coil, but no spark at the plugs, you are probably not getting any firing signal from the optics in the ignition module. Open up the nose cone end and see if it is just really dirty in there which can happen if the seal is leaking oil.