What does the p0352 code on a car mean?
The P0352 code is a generic powertrain code, which means it is supported by various makes and models and the repair process may vary from vehicle to vehicle. Make sure you are employing a fix that’s appropriate for your car by consulting a repair manual or database before attempting repairs. Otherwise, you risk worsening the issue.
Is there a way to fix code p0351?
If you have one of the following codes: P0351 P0352 P0353 P0354, we will show you how to fix your car and what could be causing this codes. Most likely you either have a bad ignition coil or bad connection / wiring. The last digit of the code corresponds to the cylinder number. This is not a sponsored video. Everything is purchased by us!
How to fix code p0351 for Toyota Sienna?
Hey guys, if you have one the following codes: P0351 P0352 P0353 P0354 P0355 P0356 P0357 P0358 IGNITION COIL, we will show you how to fix it and turn your engine light off. This will relate to most cars. We demonstrated on a Toyota Sienna that is a V6 engine.
What causes a p0353 code on a cop?
Potential causes of a P0353 code include: Short to voltage or ground on COP driver circuit Open on COP driver circuit Loose connection at coil or broken connector locks Bad Coil (COP) Faulty Powertrain Control Module
Hey guys, if you have one the following codes: P0351 P0352 P0353 P0354 P0355 P0356 P0357 P0358 IGNITION COIL, we will show you how to fix it and turn your engine light off. This will relate to most cars. We demonstrated on a Toyota Sienna that is a V6 engine.
When does p0353 ignition coil C primary or secondary?
The coil driver circuit is monitored by the PCM for faults If an open or a short is detected in the driver circuit for coil number 3, a P0353 may set. Also, depending on the vehicle, the PCM may also shut down the fuel injector to the cylinder also.
How to repair a DTC p0352 ignition coil?
Find the short and repair it. If there is no voltage on the driver circuit, then turn the ignition off. Disconnect the PCM connector and check the continuity of the driver between the PCM and the coil. If there is no continuity repair the open or short to ground in the circuit.