What does the p0058 code on the oxygen sensor mean?
What the P0058 code means. When this code is stored in the powertrain control module it means that the heater control circuit in the oxygen sensor after the catalytic converter on the cylinder bank not containing cylinder one has higher voltage than expected.
What are the four O2 sensors on a Jeep Liberty?
They’re “heater control circuit high” for all 4 O2 sensors. They generally show up when the engine is hot, if I clear them on a hot engine they’ll usually come back again almo… 2010 Jeep Liberty V6, 3.7L Codes pulled P0038, P0032, P0052, P0058, and P0456.
What is the trouble code for an oxygen sensor?
The definition of the trouble code P0058 is heated oxygen sensor heater control circuit high voltage bank 2 sensor 2.
What is the p0032 code on a Jeep Wrangler?
I have an ’06 Jeep Wrangler w/4.0l, and at random intervals it throws the following 4 codes: P0032, P0038, P0052, and P0058. They’re “heater control circuit high” for all 4 O2 sensors.
What happens when the oxygen sensor goes bad on a Jeep Liberty?
More often than not, when an oxygen sensor in your Liberty goes bad, it will throw a diagnostic trouble code. There are many oxygen sensor related codes. These codes correspond with what side of the engine they are on (known as the “bank” for cylinder bank) and how far down stream they are.
Why does the Check Engine light come on on Jeep Liberty?
Oxygen sensors can change the way that your Liberty’s engine runs. Most of the time, the check engine light will come on. It’s a good thing that the check engine light would come on, as there is more than one oxygen sensor, and they can be difficult to get to and test.
What causes a P0158 code on an O2 sensor?
Potential causes of an P0158 code include: Bad o2 sensor (Bank 2 Sensor 2) Wiring in contact with exhaust components Engine running rich (If other codes are present) Holes in exhaust causing PCM to over-rich engine resulting in an abnormally high Bank 2, sensor 2 reading Short to voltage on signal circuit Bad PCM
I have an ’06 Jeep Wrangler w/4.0l, and at random intervals it throws the following 4 codes: P0032, P0038, P0052, and P0058. They’re “heater control circuit high” for all 4 O2 sensors.