What does the master cylinder do on an ATV?
For a little background information, the master cylinder holds an ATV’s brake fluid and acts as a pumping device to pressurize the brake lines, activating the brake calipers. We knew our master cylinder needed attention because the brakes were starting to feel spongy and not holding pressure. After removing…
Where can I buy brake parts for an ATV?
Fortunately, there is a wide range of quality and reasonably-priced components offered on the market, which will help you do just that. Our ATV brake parts are supplied by such companies as Quad Boss, Lonestar Racing, and Hess Motorsports.
Where can I get a master cylinder kit?
Master cylinder kits are available from your local dealer and are only about $30.00 depending on the model and make of your ride. You will need some extra brake fluid to refill the reservoir.
How do you remove the brake lever from the master cylinder?
Remove the brake lever from the master cylinder. Remove the brake lever from the master cylinder by removing a single pivot bolt, which is held in by a locking nut. This will allow you to see the plunger and rubber boot that covers the plunger.
How do you replace a master cylinder?
Now with all the tools required, to replace your master cylinder, follow the below steps: Place rags around the master cylinder and on the cars bodywork. Remove Brake Fluid Reservoir. Remove master cylinder from brake booster. Install new master cylinder to brake booster. Clean and Install Brake Fluid Reservoir.
How much does a master cylinder cost?
Though their prices vary greatly, most master cylinders basically consist of a housing, pistons, a reservoir, some seals and various sensors. Including the hourly labor, the cost of having a master cylinder replaced can range from a little over $150 to well over $500.
What are the parts of a master cylinder?
In it’s simplest form, the master cylinder consists of a housing, reservoir, piston, rubber cup, return spring and a rubber boot (manual only). A cylinder bore is machined into the center of the housing.
What is a master cylinder on a motorcycle?
The master cylinder is the component that generates all of the pressure for the braking system, and if it develops any sort of problems sealing or distributing pressure, this may be felt in the pedal. With constant use over time, the seals inside of the cylinder can wear out and form internal leaks.
Can a Honda rancher master cylinder be rebuilt?
We recently serviced our 2003 Honda Rancher before hunting season and when it came to the brake system the pads were not the only item in the death zone. In this short and sweet process we will show you how to rebuild a degraded master cylinder to keep the brakes working at their full potential.