What does the distributor plug into?
The distributor shaft is driven by a gear on the camshaft on most overhead valve engines, and attached directly to a camshaft on most overhead cam engines. (The distributor shaft may also drive the oil pump.)
How to replace spark plugs and distributor cap?
Both the cap and rotor should only be a couple screws holding them in. Next put the new cap on, then one at a time start replacing the old wires with new ones. Once all the wires are back in, then I move onto the plugs, and same thing, only do one plug at a time.
Can a engine start with a new distributor?
This step is crucial – if the position of the rotor in your new distributor doesn’t match the position of the rotor in your old distributor, your engine may not start with the new distributor installed. Carefully make a mark inside the distributor housing to indicate the position of the rotor.
Where is the distributor on a V6 engine?
Look for the distributor – often, this is a cylindrical part with thick wires coming out of it that sits near the engine. Most distributors are located above ordinary V6 and V8 engines and to one side of inline I4 and I6 engines. The distributor has a plastic cap with spark plug wires coming out of it.
How do you change the distributor cap on a boat?
I would recommend, remove the distributor cap with all wires still attached, then change out the rotor (make sure the new rotor goes on in the same position as the old, it should be keyed, but the extra time spent being careful about the clock position will pay off). Both the cap and rotor should only be a couple screws holding them in.
Where can I buy a new spark plug?
The tools shown are available at online suppliers and auto parts stores. While you’re there, ask the clerk for the spark plug gap and torque specifications for your vehicle. And buy a small packet of dielectric grease. It’s also important to ask about spark plug replacement cost before making an appointment.
Where to put a distributor on an engine?
To make it a little easier to install the new distributor, it’s a good idea to mark a location on the outside of the distributor housing where the distributor is mounted to the engine. Choose a spot for which you can find a corresponding location on the new distributor.
Where does the Spark Go in a distributor?
When the engine is running, high voltage created by the ignition coil travels through the coil wire to the ignition rotor. As the ignition rotor turns in the distributor, the rotor distributes the spark by sending it in a synchronized order through the spark plug wires to the spark plug located in each of the engine’s cylinders.
When do spark plugs need to be replaced?
Rough engine idle. When your engine is not under acceleration (idling), it should run smoothly and consistently — if the plugs aren’t performing correctly, it will shudder and hesitate. Trouble starting the car.