What does code C1201 mean?
C1201 Brake control / Dynamic control system : Vehicle stability control system. This code is for the ABS / Dynamic control system, when you set this code it is because you have a DTC (diagnostic trouble code) that is stored, This is the “P” code which is for the powertrain system.
What is code C1231?
C1231 – Steering Angle Sensor Circuit Malfunction.
What is a steering angle sensor?
The steering-angle sensor is fixed onto the steering shaft, where the hub gear wheel of the sensor transmits the rotary movement of the shaft to two measuring gear wheels. This measuring principle enables the measurement of the complete angle range of several steering-wheel turns without the use of a rotation counter.
How do you calibrate a Toyota steering angle sensor?
SAS calibration on Toyota Yaris
- Check that the steering wheel is in the straight-ahead position.
- Check that the shift lever is in neutral and apply the parking brake.
- Turn the ignition switch to ON.
- The warning light and indicator light come on for three seconds to indicate that the initial check is completed.
What does c1201 code on Check Engine light mean?
Either an improperly installed cap or a worn out one. The C1201 code is the one that tells the vehicle to turn on the check engine light and disable the traction and VSC. Basically, when the other two codes pop up, this one is in charge of letting you know there’s a problem.
How much does it cost to repair a Toyota c1231 code?
The cost of diagnosing the C1231 TOYOTA code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What does c1201 mean on Toyota engine control system?
The C1201 code means that there is problem with the engine and if there is another code, then you should check the other code first. The P0120 means that there is problem with the Throttle Position Sensor, which more than likely will cause the engine hesitation as well. Read more: https://www.autocodes.com/p…
How to do zero point calibration on Toyota c1201?
Using a jumper, connect and then disconnect terminals 12 (TS) and 4 (CG) at the data link connector 4 times or more within 8 seconds. Toyota C1201 zero point calibration.