What does at temp mean on a Honda Pilot?
STARTER SYSTEM signifies there’s an issue with the Honda Pilot’s starter. A/T TEMP signifies your auto transmission is too hot and you should pull over and switch your vehicle to idle until the light turns off.
Is the low tire light on Honda Pilot?
I had low tire light on on 2011 pilot. Tire pressure was fine. Took it to tire dealer who hooked up scanner and the left rear tire monitor was sending 7psi to computer Replaced the sensor and $80.00 later good as new. Did you find the recommended reading relevant to this discussion?
What is the trouble code on a Honda Pilot?
One of the most common trouble codes with all Honda vehicles is the P0420. This code number references a number that is given to you when you plug your Honda Pilot into a OBDII scanner. It doesn’t matter which model you have, this OBDII code has the same meaning for all of them.
How big should the pilot light be on a thermo couple?
The thermo couple tip should 3/8″ ABOVE the “pencil Pilot Tip”, should read about 30mv. 2. Once opened the burner door. Manufacture requires installing a new gasket around the burner door to prevent CO and air leakag.
Why is my Honda Pilot not passing emissions?
The software in your vehicle believes that the catalytic converter is no longer doing its job. If your vehicle has the P0420 code, it won’t pass emissions so please be aware of that. The P0420 code in a Honda Pilot will often be thrown one of your oxygen sensors are not functioning properly.
I had low tire light on on 2011 pilot. Tire pressure was fine. Took it to tire dealer who hooked up scanner and the left rear tire monitor was sending 7psi to computer Replaced the sensor and $80.00 later good as new. Did you find the recommended reading relevant to this discussion?
What should I do if my furnace pilot light is not working?
Turn the electrical power to the furnace back on. Set your thermostat to your desired temperature. After a few seconds, the pilot will light up, igniting the furnace’s burners. If you smell gas at any point or if you are unable to get the furnace to light using this technique, stop working on your furnace and call a repair service.
What to do if your automatic pilot light is not on?
Call a technician if you are unable to reset your automatic pilot light on your own. When your furnace fails to ignite, the first place to look is the pilot light. The most common reason for this problem is because the pilot light is not on.
One of the most common trouble codes with all Honda vehicles is the P0420. This code number references a number that is given to you when you plug your Honda Pilot into a OBDII scanner. It doesn’t matter which model you have, this OBDII code has the same meaning for all of them.