What does a resistor do on a golf cart?
The purpose of the pre-charge resistor between the large terminals of the solenoid is to keep the filter capacitors inside the controller charged to near the battery pack voltage so the solenoid contacts don’t arc as much as they close.
Do I need a resistor on my golf cart solenoid?
1 – One is a resistor and one is a diode and yes they need to be there. The resistor keeps a slight pre-charge to the controller and the diode prevents back feed spikes to the controller. The cart will run without them but it’s not recommended. Ask Alltrax and they will tell you to leave them on the solenoid…
How do you test a golf cart resistor?
place the red led into the wire coming of the 3 bolt and the black into the the wire coming from the 1st bolt. now with the cart off the ground make your battery connections, turn on the key and place the f/r switch in the forward postion. As you slowly press the pedal you should get ohm readings.
What causes a golf cart to not start?
A Bad Solenoid. Another common reason for golf cart failure is a bad solenoid. The solenoid is a critical component to your golf cart because it is the main switch that connects the current from the battery to the traction motor. That clicking noise that you hear when you press the gas pedal is the solenoid.
How to fix an EZGO golf cart that won’t start?
1 Check the wiring for any damage or corrosion. 2 If there are no damages or corrosion, then simply tighten the connection to the solenoid and try again. 3 If it still won’t start, most likely there is a problem with the battery. 4 When you start the EZGO golf cart, it should only drop a little.
Why does my Volkswagen Golf not turn on?
The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Golf won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
How to troubleshoot a club car precedent golf cart?
Troubleshooting problems with the 2010 Club Car Precedent golf cart is always through the trial and error method. You keep checking and eliminating the cause of the problem one after the other. When the cart won’t move, you have to be sure that the batteries are sending sufficient power to the circuit. You must check the fuse.
https://www.youtube.com/watch?v=CkPwC_kdLmU