What do you do when the electronic throttle control light comes on?
Solution: Stop driving your vehicle and have it towed to your mechanic. There, the first step will be to scan the engine computer for a trouble code. This should point your mechanic in the right direction. If there is no code, then a check of the sensors, relays, and wiring in the system should identify the problem.
When does the Lighting Bolt light come on in a Jeep Wrangler?
When I start my jeep in the morning the lighting bolt light and the check engine light come on, and the engine does like a half crank. It turn off after a few seconds is this a good thing or a bad thing. My jeep is a month old 600 hundred miles. He’s no good to me dead.
How do you turn off a light on a Jeep Wrangler?
Cycle the ignition key when lever is placed in the PARK position. The light should turn off. If the light remains on with the engine running, authorized dealer for service as soon as possible. stall and your vehicle may require towing. The light will and remain on briefly as a bulb check.
Can a lightning bolt put a car in limp mode?
Today I was driving on the highway, and a Red Lightning Bolt started to flash on my dash, and the car immediately lost power while driving, and went into a limp mode from what I could tell. While limping on the side of the road, and red light still blinking, the Traction Control Light came on as well.
What should I do if my light bolt light is still on?
Electronic Throttle Control (ETC) Light Electronic Throttle Control (ETC) system. If a the nature of the problem. Cycle the ignition key when lever is placed in the PARK position. The light should turn off. If the light remains on with the engine running, authorized dealer for service as soon as possible. stall and your vehicle may require towing.
What do you do when you get a lightning bolt in your Jeep?
To reset it, turn your key to on without starting the car. Next, depress the gas pedal all the way to the floor then let it up again. Next, start up your car and press down the throttle to see if your Jeep responds.
When I start my jeep in the morning the lighting bolt light and the check engine light come on, and the engine does like a half crank. It turn off after a few seconds is this a good thing or a bad thing. My jeep is a month old 600 hundred miles. He’s no good to me dead.
Why does my Jeep Venturi have a red lightning bolt?
I reset the codes and the lightning bolt has not been back in about a month. The red lightning bolt in the center of a venturi is the warning lamp for the drive by wire or electronic throttle. If the PCM recognizes a fault in the drive-by-wire, it will react by reducing the gain opening the throttle significantly. To prevent a runaway engine.
What does a red warning light on a jeep mean?
Most warning lights are pretty much straight forward but what does the red lightning bolt symbol in a Jeep mean? The red lightning bolt indicates that there is a problem with your Jeep’s Electronic Throttle Control (ETC). This is a system that replaced the mechanical throttle mechanism with a sensor based one.