What causes intermittent stalling on a Ford Escape?
Ford has also issued a recall (04S13) for 2001-2003 Ford Escape sport utility vehicles with 3.0L V6 engines for an intermittent stalling problem. The stalling typically occurs while decelerating at speeds below 40 miles per hour. The problem is caused by the calibration of the idle air control valve and evaporative emissions system.
Why does intermittent stalling occur in a car?
One of the more unusual causes of intermittent stalling we’ve heard about is a defective vehicle speed sensor. When the vehicle stops moving, the PCM may not engage the idle speed motor (carbureted engines) or idle air bypass motor (fuel injected engines) so the engine will idle normally.
What causes Ford Focus to stall in cold weather?
According to Ford TSB 04-21-13, a cold stalling problem with 2003-2004 Ford Focus models with 2.0L SPI engine during extremely cold weather can be caused by a faulty PCV valve that sticks open, allowing too much air to be sucked into the intake manifold.
Why does my PCM stall when I Turn on the engine?
The MAP sensor senses intake vacuum, which the PCM uses to estimate load so it can adjust the air/fuel mixture accordingly. If the MAP sensor isn’t reading right, the PCM will receive bad information and possibly add or subtract more fuel than it should causing the engine to stall.
Why does my car stall after 20 minutes?
However, it has developed the stalling issue you have posted this last week. Its happened maybe 10 times in the past 3 days and happens after about 20 minutes running. The car will simply coast with the engine running but no response from the accelerator pedal.
Is there check engine light for intermittent stalling?
Many times, there will be no check engine light and no fault codes to give you a clue as to what might be causing the engine to stall. So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop.
Can a bad crankshaft sensor cause the engine to stall?
If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall. This is usually a symptom of a wiring problem, however a bad crankshaft position sensor can also produce this symptom.
Can a stalling engine be intermittent driveability?
Intermittent driveability problems of any kind are always a challenge to diagnose. When a customer brings you a vehicle and complains of a stalling problem, you may not have much to go on other than their description of what’s happening and when it happens.