What causes an airbag warning light to go off?
Common problems with the airbag system can occur when you are performing work on the vehicle. For example, removing the steering wheel (which houses the airbag) and then powering on the vehicle will cause this fault since the airbag is no longer attached.
What does a malfunction indicator light mean on a car?
However, it does not indicate a single fault and this lamp may go on as a result of many different faults. This may light up in case of incorrect or non-standard fuel intake, oxygen sensor failure, air flow sensor failure, EGR valve fault, and catalytic converter failure problems.
Where can I find the air bag light code?
You can read the number of flashes and it will give you a code (codes listed below for ford ranger and Mazda B3000). If your code is not listed, just google the year, make and model of your car along with “airbag light code” (ex. 2001 Mazda B3000 airbag light code).
Why does the airbag warning light come on?
You may already know which light we’re referring to — the airbag warning light. When the airbag warning light turns on, it could be signaling a minor fault in your sensors, or it could be a far more serious issue.
What makes the SRS airbag warning light work?
An airbag system consists of a few sensors, a module that interprets the signal, and an airbag that contains a small charge that allows it to deploy during an accident. These sensors can become worn and torn after time, most commonly in the passenger-side occupancy sensor and the clock spring.
What does the malfunction indicator light ( Mil ) mean?
People usually get interested in the On-Board Diagnostics when the Malfunction Indicator Light illuminates on the dashboard of their cars. The Malfunction Indicator Light (MIL) is also known as the Check Engine Light. The purpose of this warning light is to indicate a detected problem with…
When to turn off the malfunction indicator light?
The DTC will give information about the detected issue. The OBD2 system can turn the MIL off automatically if the conditions for the problem stop to exist. After evaluating a system or component for three consecutive times without detecting the problem, the light can be turned off. But, usually the light remains on. What are the next steps?