What causes a p3004 fault code on a Toyota Prius?

What causes a p3004 fault code on a Toyota Prius?

P3004 – Power Cable Malfunction. The P3004 fault code is caused by a power cable malfunction in the Toyota Prius. There are several common causes for this fault code to be displayed. These include incorrect battery voltage levels, a blown fuse, a malfunctioning voltage sensor or incorrect limiter resistance. When this fault code is scanned…

What to do if your car has a p0304 code?

Use FIXD to scan your vehicle to verify P0304 is the only code present. If other codes are present, they must be addressed first. Check for loose connectors at the ignition coils or for damaged wiring (specifically cylinder 4). Look for loose engine ground wires as well. These can cause random misfire conditions. Tighten or connect where necessary.

Where is the Diagnostic Code on a Toyota Prius?

Prius Hybrid NHW11 1.5 NZ-FXE 2001-2003 OBDII Fault Codes are OBDII type. The DLC (diagnostic connector) is located under the dash on the drivers side. NOTE! The Hybrid Control ECU may contain Fault codes that affect petrol engine ECM operation. Manual Fault Code Extraction:

How to extract a fault code from a Toyota Hybrid?

The Hybrid Control ECU may contain Fault codes that affect petrol engine ECM operation. Manual Fault Code Extraction: Switch OFF ignition and wait 10 seconds before re running any Fault Code Extraction. 1. Ensure ignition is OFF. 2. Bridge terminals #4 and #13 at the Diagnostic Connector. 3. Switch Ignition ON. 4.

Why does my Toyota Camry engine not start?

There are a lot of issues that can cause your Camry to crank, but not start. The engine needs air, fuel, and a spark in order to run. It is highly likely that if the engine is cranking, but not starting that it has thrown an OBDII code. It is definitely worth it to use an OBDII scanner to check and see if the engine has thrown any trouble codes.

When does a Toyota Prius battery malfunction?

130 – High Voltage (HV) Battery Malfunction. When HV battery voltage becomes lower than inverter voltage 131 – Power Cable Malfunction. When the main fuse is blown out, service plug is disconnected or limiter resistance is cut off 133 – High Voltage (HV) Battery Malfunction.

Why does my Camrys start in the Cold?

However, a click indicates that your starter has given up. If you drive a diesel vehicle (older Camrys), think about the amount of fuel you have in the tank first. The so-called winter diesel contains additives so that it does not become too thick or even solid in the cold.