What causes a p0753 trouble code on a PCM?
A common cause of the storage of a P0753 trouble code in the PCM is a faulty shift solenoid. Some other causes include blockage in the hydraulic system inside of the transmission, a mechanical failure in the transmission, a low transmission fluid level, and dirty or contaminated transmission fluid.
When to replace a shift solenoid p0753 trouble code?
A common mistake made by mechanics when diagnosing a P0753 trouble code is to replace a shift solenoid because they believe it has caused the problem, when in actuality the problem lies somewhere else. How serious is the P0753 code?
What are the trouble codes for an a solenoid?
The trouble codes related to this, the “A” solenoid, are codes P0750, P0751, P0752, P0753 and P0754 based on the specific malfunction that alerts the PCM to set the code and illuminate the Check Engine Light. These codes will also be associated to the A, B or C solenoid circuit.
When is a p0750 code detected on a transmission?
The P0750 code is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve. Transmission will not shift gears.
What is the p0705 diagnostic trouble code ( DTC )?
The P0705 diagnostic trouble code (DTC) refers to a switch either external or internal on the transmission whose function is to signal the Powertrain Control Module (PCM) or the Transmission Control Module (TCM) as to the gear shift position — P, R,N and D positions (park, reverse, neutral, and drive).
A common mistake made by mechanics when diagnosing a P0753 trouble code is to replace a shift solenoid because they believe it has caused the problem, when in actuality the problem lies somewhere else. How serious is the P0753 code?
A common cause of the storage of a P0753 trouble code in the PCM is a faulty shift solenoid. Some other causes include blockage in the hydraulic system inside of the transmission, a mechanical failure in the transmission, a low transmission fluid level, and dirty or contaminated transmission fluid.
When was the transmission recall on my 2005 Sorento?
I did the transmission recall in November 2008 and had to take back my 2005 sorento 5 times where they told me nothing was wrong but then found other problems to charge me $1,500 for. When I took it to a mechanic to check it out they found that the transmission fluid wasn’t replaced after the repair was done.
Where is the low reverse shift solenoid located?
Now, just in case you’re not aware, the Low Reverse Shift Solenoid (Shift Solenoid A) is part of the transmission coil pack (this also means that if your tests indicate it’s bad, you’ll need to buy the whole solenoid pack to solve the problem). The transmission coil pack is bolted to the transmission (see the photo at the top of this page).
Can you erase a fault code on a Mercedes Benz?
Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS This is diagnostic scanner used at Mercedes-Benz dealerships.
What are all the codes on a Mercedes Benz?
Use an advanced OBD-II code reader to read and erase Engine CEL, Transmission, ETS, ABS, Airbag and other systems. There are also codes for other control units such as transmission, ABS, SRS, ESP, 4ETS, airbag, A/C. Mercedes-Benz can have up to 47 control units. You can NOT diagnose them with a simple OBD-2 scanner.
Can you read the fault code on a Mercedes Benz?
Can read fault codes from multiple systems such as transmission, engine, ETS, airbag and more. Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS