What are the transmission problems on a Chevy Equinox?
Continous problems with the transmission, noise at start-up and wind problem with drivers side door. Chevy should be ashamed to put a vehicle out with such a junk transmission. Todd: Give us a call at 800-LEMON-LAW to see if we can help you resolve this issue. 2011 Equinox with 400 miles and the transmission exploded.
Why are my front brakes making a squeaking noise?
Loud Brakes: Some owners report that front brake pads are making a squeaking or grinding noise when the brakes are applied. In 2016, Toyota issued a TSB and had dealers replace the brake pads and resurface the rotors under warranty.
What to do if your Chevy Equinox is bucking?
Service advisers cannot figure out how to fix the problem, nor can they identify how it is connected to the air conditioner. If your Chevrolet Equinox is bucking or lunging, make sure you get to an authorized Chevrolet dealership to have the matter addressed. If necessary, take the service adviser for a test drive to illustrate the situation.
What was the difference between a Pontiac Tempest and a Buick Special?
The driveshaft’s slight sag allowed a lower transmission tunnel in front, though not in back; it also eliminated the need for U-joints and permitted softer engine mounts for better interior isolation. The rear transaxle, a first for Detroit (but not the world), made Tempest less nose-heavy than conventional cousins Olds F-85 and Buick Special.
How to disassemble a transmission mounted parking brake?
Transmission Mounted Parking Brake Assembly 1.Press the plug into the output flange if plug was previously removed. Apply sealer to the lip of the plug. Press into place with the lip of the plug facing outward. The plug must be flush with the edge of the bore. Transmission Mounted Parking Brake Shoe Disassembly And Assembly =R R P 6L]HG I RU3ULQW
How do you replace GM parking brake shoes?
On the GM shoes an updated clip is included which helps prevent the shoe from dragging against the rotor when the parking brake is not engaged. Gently place the new shoe over the axle flange and rotate it into position. Start with the lower part of the shoe over the axle flange and work it around.
Where is the parking brake actuator on a car?
The parking brake actuating lever will still be attached to the rear shoe. While grasping the parking brake cable spring, move it upward on the cable to create room to remove the brake shoe actuator arm from the cable.
How are parking brake shoes held in place?
The tool will have a tang on the round part which catches under the spring and forces it from the backing plate. Insert the tool over the brake shoe return spring pivot and twist to release. Do this for both forward and rear facing shoe springs. These shoes are held to the backing plate by a small spring, pin and retainer assembly.