What are the side steps on a Toyota Tacoma?
Using our retractable Toyota Tacoma truck bed steps, reach for that cargo with ease and safety, while giving your back a break. Furthermore, bring efficiency and security to hauling awkward loads with Toyota Tacoma cargo cages and Toyota Tacoma truck bed extenders.
What kind of running board do I need for my Toyota Tacoma?
Check out the AMP Research BedStep2 kit on your Dually model trucks. This kit is designed specifically for the BedStep2 and is required on all cabs except Mega Cab. The AMP Research Bracket Kit is designed to be used with the 2014-2020 Ram Dually for ease of install to the AMP Research Bed Xtenders.
What do I need to install AMP Research running board?
The AMP Research Air Tank Relocation Kit is required for installation of AMP Research PowerStep Running Boards on Ram 2500/3500 models. Alloy fuel door for Jeep Wrangler JK Aluminum Alloy is made from die-cast aluminum alloy. This fuel door cover features expressive styling that compliments the body lines.
Which is AMP Research powerstep is right for You?
A pair of AMP Research Powersteps will make your truck, Jeep, or SUV feel like a brand new ride! Which PowerStep is right for you? Getting into your truck shouldn’t feel like climbing mount everest!
OE Style Running Boards Side Steps Nerf Bars for 2005-2021 Toyota Tacoma Double Cab/Crew Cab with 4 Full Size Door (2pcs),3.5 Inches,Drop Step,Heavy Duty Carbon Steel. . . . .
Can a 2.7 engine start on a Tacoma?
The 2.7 in the Tacoma was a breeze. [/FONT] It was so easy I would tell anyone with a high mileage 2.7 engine to go ahead and repair the starter because it is just a matter of time before the contacts wear down enough to the point that it will be hard to start or get to the point that it will not start.
How do you replace an O2 sensor in Tacoma?
Step 1: Unscrew the 2 nuts retaining the bad sensor. Step 2: Unclip harness. Use a screwdriver to pry the retaining tab off of the hook Step 6: Tighten nuts back on, and tighten the sensor *firm* but not to hard. Its not pressurized like a spark plug, so it doesnt need to be torqued down. Just tight with a quarter turn for peace of mind
How to remove a starter from a Toyota Tacoma?
Take a screwdriver and pop the plastic cover back so that you can access the nut. Take a ratchet and remove the nut. Take a pair of pliers or a screwdriver and disconnect the black connector. The top bolt is a little tricky.