Is there a problem with my Mazda BT-50?
One of the most common issues your Mazda BT-50 is likely to develop is a stalling problem. The most challenging part of diagnosing a stalling problem is reproducing the conditions that led to the stall in the first place. Stalls can happen at any time, and it can be incredibly jarring when it does happen.
How to heat a 2012 Mazda BT-50 pro?
Open the centre and side air vents. Direct the centre air vents upwards and the side air vents toward the side windows. Recommended settings for heating Make sure that you fully engage the locking lever when returning it to its original position. Select the outside air. Close the centre air vents and open the side air vents.
Where is the throttle position sensor on a Mazda BT-50?
Your Mazda BT-50 uses a series of complex sensors to report what is going on to the ECU. The ECU then uses this information to adjust the timing, air fuel mixture, and more. When one of them goes wrong, it can lead to stalling for sure. Throttle Position Sensor– The throttle position sensor is typically located on the gas pedal.
What should I do if my Mazda 3 Dashboard Light comes on?
Immediate action is required if this light comes on else engine components may be damaged. Other symptoms include a loss of power, knocking or pinging noise. Immediately and as soon as safely possible, pull over and switch off the engine. Allow 15 minutes or so for engine to cool down. Check for water leaks. If no leaks, continue driving.
How does the cooling system on a Mazda BT-50 work?
Your BT-50’s cooling system works by cycling the engine coolant from the engine through the radiator. The water pump pushes the water through the entire system. The thermostat opens up once the engine reaches operating temperature and allows coolant in. If any part of this system fails, your BT-50 will eventually overheat.
What was the ABIT on my Mazda BT50?
-Fuel gauge showed abit over ½ when I left home. -15mins in the fuel light suddenly comes on and the distance to empty drops from several hundred km (can’t remember) to 80km, then 40km, then zero within 15 seconds. -I kept driving knowing there was plenty fuel…I would look into it during the day.
What are the symptoms of a Mazda BT-50 overheating?
If your BT-50 is run for too long of a period while overheating, the head gasket may blow. Bad head gasket symptoms include white smoke coming from the tail pipe, rough idle, and oil in the coolant. Shutting down before it overheats, or as soon as you see that it is overheating will usually prevent this from happening.
What to do if your Mazda loses power?
My three-year-old Mazda BT-50 suddenly lost power recently when I was driving it, and the powertrain and traction control warning lights came on. I pulled over and turned it off.