Is there a parking brake switch on a Jaguar?
The auto electrician was able to operate handbrake release mechanism etc through the diagnostic computer. He told me he was on the phone to jaguar enquiringly about a parking brake switch and they don’t come as just a switch you have to purchase the entire panel and everything needs to be coded into the car.
Why is my hand brake not working on my Jaguar?
With the recent cold snap I have replaced my battery as it was 10 years old and dropping below 12 volts making some mornings difficult to start up. I tried a EPB reset after replacing the battery and I managed to apply the hand brake but as soon as I removed it and moved the car forward the fault came back on the dash.
How do you reset the EPB on a Jaguar?
This indicates that the parking brake is in calibration mode. 5. Lightly press the footbrake pedal. 6. Apply the parking brake by using the EPB switch. 7. Release the parking brake. 8. Release the footbrake.
Do you need to change the rear pads on a Jaguar?
For those who want to change the rear pads Jaguar recommend that the EPB (hand brake) is calibrated as detailed below. procedure in this bulletin. Failure to do this may result in incorrect operation of the Park brake, with warning lamps
Where to find electric parking brake on Jaguar?
See ELECTRIC PARKING BRAKE (EPB) (RED). The warning lamp in the Instrument panel will remain on for a short time, if the EPB is applied when the ignition system is reverted to Convenience mode. If a fault in the system is detected, Park Brake Fault or Cannot Apply Park Brake will be displayed in the Message centre.
Do you need to change the brake pads on a Jaguar XF?
Yes, changed the rear brake pads four times across two XFs – 2010 XFS and 2010 XFR – and all you need do is make sure the EPB is not engaged before you start. The brake piston pushes back quite easily with just the wind back tool and no need for any electrical shenanigans and your last sentence is spot on.
Where is the EPB switch on a Jaguar?
The switch which operates the EPB is mounted on the centre console, to the rear of the gear selector. To disengage the EPB ( 1 ): With the ignition system on, or with the engine running, apply the brake pedal and press down on the EPB switch.
What to do if the battery has been discharged in a Jaguar?
If the battery has been discharged or disconnected, Apply Foot And Park Brake will be displayed in the Message centre when the ignition is next switched on. Press the brake pedal and pull the EPB switch up to apply the EPB. This is required to reset the EPB system. The EPB will now function correctly.