Is the 2009 Hisun 700 a Yahama clone?
Great Infromation. Thanks .Can some confirm that , I am buying one title says Sunl – that the 2009 Sunl 700 was buit by Hisun and it is a 95% Yahama 2009 Rhino 700 clone. Friend is sells it to me the issue is timing chain adjustor off for second time.
Where is engine no.carved on Hisun 700utv?
Engine NO. is carved on the right side of the engine, fighre 1-2 fighre 1-2 1.2 Special tools, instruments and meters 1.2.1 Oil filter detacher To fasten and detach the oil filter 1.2.2 Height gauge…
Where are the punch marks on a Hisun 700?
Take a center punch and mark (dot) close to the bend AND close to the D hole (but not too close for mounting screw and washer)…the punch marks are for the correct reassy of halves AFTER you cut the bracket IN HALF across the wide area. 1/8″ to 3/16″ with cutoff wheel is removed and then use a wire welder to make it WHOLE again—-JUST SHORTER.
What is the maintenance manual for Hisun 700utv?
3. 3.2 2 2 2 piston and connecting rod ①remove the piston snap ring Note: block the crankcase breather with a piece of cleaning cloth to avoid the snap ring falling into the case .See figure 2-36. Figure 2-36 ②remove piston pin and piston Clean the buckle of piston and piston pin hole to facilitate the removing of piston pin. Figure 2-37 3. 3.
Great Infromation. Thanks .Can some confirm that , I am buying one title says Sunl – that the 2009 Sunl 700 was buit by Hisun and it is a 95% Yahama 2009 Rhino 700 clone. Friend is sells it to me the issue is timing chain adjustor off for second time.
Take a center punch and mark (dot) close to the bend AND close to the D hole (but not too close for mounting screw and washer)…the punch marks are for the correct reassy of halves AFTER you cut the bracket IN HALF across the wide area. 1/8″ to 3/16″ with cutoff wheel is removed and then use a wire welder to make it WHOLE again—-JUST SHORTER.
What is the check valve on a Hisun 700?
Check valve—–foot valve in a water well system—–I found that only one in tank pickup (gumdrop) will flow at the slight draw the fuel pump generates to crack open the check valve. It also had a fine mesh screen to keep grass, weed seeds, etc. out of the fuel intake.
Why is my Hisun 700 hard to start?
Heat soak floods intake (expansion) and as an added bonus, the fuel looses it’s POP. used this trick on multiple golf carts that were hard to start. SHIFT PROBLEM. looking at the supplied image, notice the shift linkage adjustable rod….REMOVE one end coupling.