Is Mazda RX8 good on gas?
Find and Compare Cars
| 2004 Mazda RX-8 | |
|---|---|
| Personalize Find a car | 2 cyl, 1.3 L, Manual 6-spd Compare |
| Fuel Economy | |
| EPA MPG | Premium Gasoline 18 combined city/highway MPG 16 city 22 highway 5.6 gals/100 miles |
| Unofficial MPG Estimates Shared by Vehicle Owners | View Estimates How can I share my MPG? |
Are there any problems with the Mazda RX8 engine?
During 2004-2005, there were numerous reports of RX-8 engine failure. Soon, the reputation of the engines was beginning to take shape. It was basically an engine that could only last for many owners up to 30,000 miles. Many Mazda owners were experiencing issues such as power loss.
What makes the Mazda rotary engine one of the most useless?
With the Mazda’s rotary style engine, come a host of well-document problems. What makes the rotary engine one of the most useless engines out there? By design the Wankel engine as a low thermal efficiency. Part of this is due to the fact that they also have low compression ratios- with the poorly made shape of the combustion chamber.
How do you warm up a Mazda RX8 engine?
You need to warm up the engine slowly, stay in low revs depending on outside temperature for at least 20 minutes. Beware you need to warm up the oil, and the gauge on your dash is the water temperature, which heats up a lot faster! After that, drive it like you stole it.
How many intake ports does the Mazda RX8 have?
Mazda also delayed the intake port closing time to allow for greater intake volume. In the 4-port, you have 2 intake ports per rotor; in the 6-port, there are additional auxiliary ports. To really capitalise on the improved engine airflow, the RX8 implements a complicated intake system.
How does the Mazda RX8 Renesis engine work?
(See NO.8 ENGINE RUNS ROUGH/ROLLING IDLE .) 9 Fast idle/runs on The engine speed continues at fast idle after warm-up. The engine runs after the ignition switch is turned off.
Why is my Mazda 3 idling and almost stalling?
Try a fuel system cleaner like seafoam. Will probably fix the problem. If not then you probably pulled one of the wires on your MAF. When mine was acting up (right before I extended the MAF wires) I couldn’t tell if the wires were pulled or not but with the motor running just a slight tap or wiggle of the wires would stall the car.
How to troubleshoot an RX8 rotary engine?
(w) RX8-Engine Troubleshooting Page 2 Inspection Method for Sensor Connectors or Wires 1. Connect the WDS or equivalent to the DLC-2. 2. Turn the ignition switch to the ON position (Engine off). NOTE: If the engine starts and runs, perform the following steps at idle. 3. Access the PIDs for the switch you are inspecting.
What happens at fast idle on a rotary engine?
(See NO.7 SLOW RETURN TO IDL .) 8 Engine runs rough/rolling idle The engine speed fluctuates between the specified idle speed and lower speed and the engine shakes excessively. (See NO.8 ENGINE RUNS ROUGH/ROLLING IDLE .) 9 Fast idle/runs on The engine speed continues at fast idle after warm-up.