Is it safe to use jet fuel injector cleaner?
This product is made with jet fuel, a high-quality carrier of active ingredients. Use every oil change or 4,000 miles. 5.25 fl. oz. bottle treats up to 21 gallons of gasoline. 12 fl. oz. bottle treats up to 28 gallons of gasoline. Take Note! STP ® Super Concentrated Fuel Injector Cleaner is safe for any gasoline engines.
Can a dead fuel injector be repaired or replaced?
Dead Fuel Injector: A dead fuel injector is an injector that does not have resistance and does not respond to electrical input.They act the same than a clogged injector. Dead fuel injectors cannot be repaired and should be replaced with the exact same unit.
What should I do if my fuel injector is clogged?
The only guaranteed method that addresses these problems and can clean a clogged injector properly is by removing the injectors from the engine. Once removed, the injectors can be dropped off or mailed to a professional injector cleaning service such as Injector RX.
How to contact a fuel off road dealer?
Fuel Off-Road is on the leading edge in off-road innovation, for new product releases stay up to date through our social media outlets, including Facebook, Twitter, You tube and Instagram. If you have a question about a current style contact your local Fuel Off-Road dealer. How do I become a Fuel Off-Road authorized dealer?
Do you need to disassemble the fuel distributor?
Disassembling the fuel control unit (the fuel distributor). You need to be especially careful and cautious here. The fuel control unit as well as the fuel distributor is a very expensive spare part and it is becoming more and more difficult to find it on a stand of a specialized shop or a market with each upcoming month.
What kind of regulator is a k jet?
Playing with your K -Jetronic Warm Up Regulator, or WUR. This little goody is a common culprit in K-jet or CIS problems, along with pumps, one- way valves, accumulators and fuel distributors.
How to clean Bosch KE-Jetronic fuel dispenser?
Use the depth gauge to measure the depth of planting adjusting screws and write down all the values. Alternately, clean the dispenser halves in an ultrasonic bath (about 15 minutes for each of both of them). After that be sure to start cleaning thoroughly and blow dry the remaining water with compressed air.
Is it possible to clean resource mechanical injector?
Nozzles are subject to mechanical wear and are almost impossible to clean. Resource mechanical injector is about 70.000 to 100.000 km. On Audi engines removing injectors is a pretty complicated operation (yet the MErcedes ones are somewhat simplier).