Is it possible to repair a heat pump refrigerant leak?
If can find the leak on your heat pump, you can repair it. In the old days, correcting a device with refrigerant leaks was a nightmare, and almost always it ended on a coil or component being wholly replaced instead of mended. However, finding the leak today can also be a tough job.
How can I fix leak on top of my water pump?
You will need to cut the pvc just above the current fitting coming out of the pump and remove the old fitting from the pump. Use pipe dope to seal the threaded end and use pvc glue to attach the slip end to the existing plumbing. You may also need a connector and some additional pipe to complete the repair.
What causes a leak from the top of a pump?
There should be an o-ring somewhere under that nut, that seals between the pipe and the pump body. O-ring damage is the most common cause of a leak in that situation. Alternatively, zea3 might be right and they used some kind of sealant instead, which will be more of a challenge to replace.
Why does my pool pump keep leaking water?
The Pool Pump is Leaking Water In most cases, a leak underneath a pool pump is caused by a pressure-side leak. This is easily combated by inspecting the impeller housing o-ring, shaft seal and replacing any worn, cracked o-rings or seals.
There should be an o-ring somewhere under that nut, that seals between the pipe and the pump body. O-ring damage is the most common cause of a leak in that situation. Alternatively, zea3 might be right and they used some kind of sealant instead, which will be more of a challenge to replace.
You will need to cut the pvc just above the current fitting coming out of the pump and remove the old fitting from the pump. Use pipe dope to seal the threaded end and use pvc glue to attach the slip end to the existing plumbing. You may also need a connector and some additional pipe to complete the repair.
How do you fix a crack in a pump housing?
I applied a bit of JB Weld around the crack (after carefully sanding off the white “crust” on the inside of the pump housing) and then laid the fiberglass strip in place, making certain that it extended at least a half-inch beyond the crack in every direction.
Is there a crack in the Hayward pump housing?
There was a crack line in my Hayward pump housing. Epoxies and other bonding products won’t work with this type of plastic and in this high pressure environment. I was not feeling like