How to troubleshoot a Suzuki outboard motor problem?

How to troubleshoot a Suzuki outboard motor problem?

1 Motor Won’t Start. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine. 2 Power Loss. Check the spark plugs and filter if there is a sudden and noticeable drop in power while the engine is at full throttle. 3 Vibrations. Inspect the propeller for damage. …

Why does my Suzuki Wagon not turn on?

Problem surfaced during rain while parked, headlps came on-wont go out,ac blower stays enabled without ign on also.Found fuse cover under dash full of water,Possible that water shorted between batt and ign-on circuits frying what is most likely a ground circuit on/in one of the controll modules.Anybody have experience with this?

How long has my Suzuki outboard been in storage?

Motor only has 5 hours on it and has been in storage for 8 years. I cleaned the old fuel out, replaced filters and fuel pump which bench tested as bad. …

How many questions have been posted on Suzuki outboard?

This is just a fraction of the 3000 plus questions that were posted, and it is hoped that this Suzuki Outboard forum and bulletin board does the same.

1 Motor Won’t Start. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine. 2 Power Loss. Check the spark plugs and filter if there is a sudden and noticeable drop in power while the engine is at full throttle. 3 Vibrations. Inspect the propeller for damage.

Why does my Suzuki Wagon not start up?

The guy who came out from TripleA tried to jumpstart the battery and it would start up, but then it wouldn’t hold the charge even long enough to drive it up on the tow truck. At the dealership they said it was just a bad battery [said there are a few bad ones in every batch.]

What to do if your Suzuki 1500lc won’t start?

Probably 75% of the people I personally know who own or have owned a pre-2005 1500LC have had this assembly fail on them. By all means check the starter relay- use your multimeter to make sure you are getting power to it, and to check the continuity.

What causes the roller to break off on a Suzuki 96?

This roller tends to break off on the 96 and up models taking the boss and a large chunk of the frame with it. This roller’s mount cannot withstand the torque of the motor which is applied to it when the suspension is compressed and the roller presses down on the chain.

Why does my 2 stroke engine not run?

The reason the machine will sit idling with no problem is because it is getting enough fuel for the level of engine speed required, however as soon as we try to increase that speed where we need more fuel there won’t be enough available. Here are 10 reasons and fixes to help prevent lack of fuel to a 2-stroke engine. 1. Mixture Screws

When to replace primer bulb on Suzuki outboard?

If there is no resistance, fuel is not entering the engine. The primer bulb and entire fuel line may have to be replaced. Check the spark plugs and filter if there is a sudden and noticeable drop in power while the engine is at full throttle. The plugs may simply need cleaning or replacing, or perhaps water has gotten into the fuel filter.

How many horsepower does a Suzuki outboard motor have?

They can range from 2.5 horsepower to 300 horsepower. Outboard motors are attached externally to the stern. Common problems in Suzuki outboard motors can be easily diagnosed from home. Inspect the primer bulb if the engine is not starting. If there is no resistance, fuel is not entering the engine.

Where does the knocking come from in an engine?

Another possible source of engine knocking isn’t actually coming from the engine itself at all. It could be coming from the accessory belt. As the engine runs, it turns a belt that’s connected to various pulleys throughout the engine bay. This belt must be under the exact right amount of tension so that it turns smoothly and quietly.

Can a bad knock sensor cause an engine to knock?

There’s even a knock sensor that’s designed to detect engine knock and tell the Engine Control Unit, so it can correct the problem automatically. This naturally means that a bad knock sensor can allow the engine to knock.

Why does my boat engine keep losing power?

Boat Engine is Sputtering and Losing Power Your boat feels like it’s running out of strength (and you’ve ruled out the No. 1 breakdown reason — running out of fuel). You most likely have a filter problem or fouled plugs. That could be why your boat motor is losing power.

What causes a 7.3 power stroke engine to not start?

7.3 Power Stroke Diesel Common Problem #1 : Causes No Start : Injection Pressure Regulator (IPR) Valve, located in the valley on the High Pressure Oil Pump (HPOP). These can stick, seals get damaged, have the sensor go bad or the wires get damaged.