How to reset the SRS light on a Honda Accord?

(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires.

Where is the SRS plug on a Honda Accord?

How do you turn off the SRS light?

MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.

What does the SRS light on a Honda CRV mean?

A Honda CRV comes with an On-Board Diagnostics computer that keeps track of all the mechanical functions of the vehicle. When you see the SRS light flash on your instrument panel, it is alerting you to a malfunction in the Supplemental Restraint System, i.e., the airbag system. Put on safety goggles and cloth work gloves.

Why is my SRS light not working on my Honda Civic?

I recently had this issue with my 1999 Civic SiR, and it turned out the issue was that the internal contact points of the car horn had corroded. Replacing the car horn, and then resetting the SRS light by disconnecting the battery for about 10 or so minutes fixed things.

What happens when you turn off the SRS light?

The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire. The SRS light will turn off. Disconnect the shorting wire.

What does the SRS light on airbags mean?

The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.

The SRS light should go off. When the light goes off, pull the wires apart. The SRS light should blink twice. Turn off the ignition to start your car as normal. The SRS light should come on, and after a few seconds it will turn off and stay off. Figure 1. Connect a pair of stripped wires to short the MES. Figure 2.

Why does my Honda SRS light keep blinking?

The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.

What should I do when my SRS light goes off?

When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal. The SRS Light should illuminate for a couple of seconds as normal and then go off.

How to reset or erase SRS airbag light?

How To Reset or Erase SRS Airbag Light on Honda and Acura. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.

How to reset my Honda Accord after changing an alarm?

Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position. The alarm should now be disabled. Start your Honda Accord’s engine and allow the vehicle to run for at least 10 minutes. This will allow the Accord to reset the alarm.

What happens when the SRS light goes off?

The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice. Turn the ignition off. Start engine as normal.

What does the SRS light mean on a Honda Accord?

The SRS, or supplemental restraint system, on your Honda Accord is responsible for deploying the airbag in the event of an accident. If this system is malfunctioning, the airbag may not deploy properly during an accident. However, the system does warn you of a system malfunction. The yellow “SRS” light on the dash will light up, indicating a problem with the system.

Why does the SRS light stay on?

If you see the SRS light on, you must work to know why. It can be due to a variety of reasons including: The malfunctioning of airbag sensors: It is common for the sensors to fail. This may cause the sensor to activate all of a sudden for no reason, causing the airbag light to stay on. Replacing the sensors may do the job.

What is SRS light?

The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system.

What does SRS stand for in Honda Civic?

Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.

What does SRS stand for in Honda Accord?

This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system , or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.

What should I do if my SRS light keeps coming on?

If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.

Is there a way to reset the SRS light?

That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.

How do you change the battery in a Honda Accord?

Lester Moorman, If possible charge your battery 12.2V+ or change it, as this could continue happening. Try alarm rest procedure below. Insert the ignition key in the Accord’s driver-side door lock. Turn the key to the unlock position. Turn the key to the lock position. Turn the key back to the unlock position.

How can I tell if my SRS light is on?

The scanner flashes slowly to indicate the first part of the numerical error code and then uses a second quick flash for the second number of the code. I recommend that you check the code and go from there. I’m guessing that it will show a “non-functional” code; this is a common problem.

Why does the SRS light keep coming on?

For example, a long flash would indicate an error code of 10. Three short flashes would indicate an error code of 3. If there is an ongoing failure, the code will flash repeatedly. If the problem is intermittent, the code will flash once, and then the SRS light will just stay on.

Where is the MES plug on a Honda Accord?

It is under the driver’s side dashboard near the fuse panel. The harness is yellow and has two wires coming out of it. Disconnect the MES plug from its socket. Strip each end of the speaker wires. Then, insert one end of each wire into each plug opening. If you don’t have wires, you can use paperclips instead.

What does it mean when SRS warning light stays on?

SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. It is very unlikely that your airbags are going to deploy randomly, but the concern is that they may not deploy…

What does the SRS light mean on a Mercedes Benz?

What does SRS light mean? SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system.

What does SRS mean when you turn on a Honda Accord?

What does the SRS light mean on my Honda?

The SRS light on a Honda accord is an indication that there is a problem with the Supplemental Restraint System. Well, there could be a problem. Honda Accord, Civic, Prelude and CRV all are known to have continuous problems with the SRS system.

Why does my car not start after shorting out the SRS light?

To make a long story short my car wouldn’t start after shorting out the SRS light when you short the SRS it fries your main control module under the steering wheel which will cause your car to not start. Never Short out anything Electronic it will not fix the problem it will make the situation worse. Was this answer helpful?

Why does my Honda SRS light not reset?

The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.

Where is the SRS unit on a Honda Accord?

The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.

Where is the SRS light on a Honda Accord?

It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires. The SRS Light will come back on.

Navigation