How to reset the Check Engine light on a Harley Davidson?
Run/Off switch. In this instance, just as any other time you work on your motorcycle, make sure your motorcycle is on a level surface and firmly on the kickstand. With the engine switch on the off position and the run/stop switch in the run position, push the odometer trip reset button and hold.
Why does my check engine light keep coming on?
A check engine light can appear for a variety of issues, and rarely is it serious. It is annoying and, at a bare minimum, every rider should be aware of the process to clear the check engine light and be able to retrieve the code to find out what it means.
How does a Harley Davidson neutral light work?
If you want the light to light for the dealer, give it a bath before bringing the bike in for them to see. The water will infiltrate the switch and as it warms up you will gradually get more and more gears that light the light until they all do as the engine gets hot.
How to reset check engine light on Harley Davidson touring?
You may think you need an expensive code scanner or computer to check and reset CEL codes on your Harley, but the Motor Company designed a diagnostic mode into the computer. All you need are your ignition keys and a finger, and a pen to write down the stored codes before resetting. This article applies to the Harley Davidson Touring (2005-2016).
What happens if your check engine light goes off?
It sends data to the vehicle’s computer, which uses it to regulate the mixture of air and fuel that enters the cylinders. An engine will keep running even if an O2 sensor needs to be replaced, but it will burn more fuel than usual. In the long run, a bad O2 sensor can damage components like the spark plugs and the catalytic converter.
How do you reset the Check Engine light?
To do that, press and hold the odometer reset button for longer than five seconds until the word “clear” is displayed. Once you see the word “clear,” release the reset button. Repeat these steps as you cycle through the codes. Or, if you don’t want to clear the code, click the button until the display reads “END,” meaning the end of the codes.
What did the battery light come on on my Harley Davidson?
Rode about 70 miles yesterday. Everything was fine as usual. Stopped for gas. She fired right up. As soon as we hit the road the battery and engine light came on. Pulled into the next gas station and shut her down. Waited a few minutes and she started right back up but lights still on. Headed home.
Run/Off switch. In this instance, just as any other time you work on your motorcycle, make sure your motorcycle is on a level surface and firmly on the kickstand. With the engine switch on the off position and the run/stop switch in the run position, push the odometer trip reset button and hold.
Can a check engine light be tested intermittently?
Testing for an intermittent problem is useless if the actual symptom is not present . The hardest part of these check engine light issues is re-creating the fault, but it is also the most important!
What should you do if your check engine light is blinking?
According to Consumer Reports, blinking could indicate an emergency. If the light is blinking, pull over, turn the car off, and call for assistance. A steady light means there’s no immediate cause for alarm, but you should still get it checked out.
What does it mean when your check engine light says gas is leaking?
If you get an error pointing to the gas cap, it means fuel vapors are leaking out of your cap. This means it’s either cracked or just wasn’t tightened well enough.