How to replace upper control arm ball joint?
Upper Ball Joint Replacement. This video will show you how to replace the Upper Control Arm Ball Joint on a Chevy Trailblazer, GMC Envoy, etc. Replacing a ball joint is fast and easy and can be done with basic hand tools and a ball joint press you can rent for free at your local parts store.
How do you remove the ball joint from a lawn mower?
Removing the Old Ball Joint Pull the cotter pin and loosen the large castellated nut. The top should look like a crown, or castle, at the bottom. Pop loose the ball joint. The goal is to try to guide it through the hole in the upper half of the steering knuckle. Remove the allen bolts and slide the control arm free.
How to replace a steering knuckle hole in a soccer ball?
Guide the new joint through the knuckle hole. Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. 2 Bolt the joint into place using the hardware included.
Is it easy to replace a ball joint?
Replacing a ball joint is fast and easy and can be done with basic hand tools and a ball joint press you can rent for free at your local parts store. This ball joint is pressed but some are bolt on which is even easier.
Upper Ball Joint Replacement. This video will show you how to replace the Upper Control Arm Ball Joint on a Chevy Trailblazer, GMC Envoy, etc. Replacing a ball joint is fast and easy and can be done with basic hand tools and a ball joint press you can rent for free at your local parts store.
How do you remove a nut from a ball joint?
Remove the nut on the bottom of the upper ball joint using a wrench. Separate the ball joint using the ball joint separator tool. Insert the tool between the spindle and the upper control arm and hit it with a hammer until it comes loose from the spindle.
How do you remove the upper control arm?
Remove the upper control arm by removing the nuts on the engine side of the arm holding it to the frame. Use a wrench for this, but as the bolts are loosened, keep the alignment shims together that are behind each nut.
Replacing a ball joint is fast and easy and can be done with basic hand tools and a ball joint press you can rent for free at your local parts store. This ball joint is pressed but some are bolt on which is even easier.
How do you put a new ball joint in a car?
Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. Bolt the joint into place using the hardware included.
How do you know if ball joints need to be replaced?
Inspect the ball joints to make sure they need to be replaced. Figure out if your vehicle’s got a strut-style suspension or a control arm, then check the ball joint by either jacking up the control arm near the ball joint to check for wheel play, or by jacking up the car and using a pry-bar to check for wheel play in a strut-style suspension.
How do you replace ball joint on McPherson strut?
Leave the castellated nut in place, just a few turns in to keep it in a safe place. If you’re working on a McPherson strut suspension remove the “pinch bolt” that clamps the ball joint stud. Pop loose the ball joint.