How to replace the turbo on a Volkswagen Golf GTI?
You will need to get access to the oil line for the turbo that connects to the engine at the front. At the front of the engine remove the two 10mm nuts (red arrows) holding the vacuum lines and the two 5mm Allen bolts (yellow arrows) holding the self. With the bolts removed lift the shelf up and off the dipstick tube.
Where is the oil line on a Golf GTI?
Disconnect the oil line from the front of the engine. This photo illustrates the oil line that connects to the top of the turbo (red arrow) runs along the left side of the engine (green arrow) and connects at the front of the engine (yellow arrow).
Can you replace the turbo on a GTI mark 4?
There are many reasons for removing the turbo on your GTI Mark 4, from replacing it to upgrading to a larger turbo to give the engine more power. It is not a quick or easy job, but can be done by a DIY mechanic if you take your time, have the right tools and follow the instructions.
Which is the best turbo upgrade for a GTI?
For me, the k03s is a perfect upgrade because it kicks in earlier then my k03 did and the power upgrade is also very satisfactory (230 bhp it has been rolling roaded). As mentioned on other posts, for a k03s upgrade you need: turbo, tip, 4 bar fpr and remap. For a k04 upgrade you need: turbo, tip, injectors, new downpipe, oil/water lines (I think).
What happens to timing belt on golf 1.8T?
The 1.8T Golf is an interference engine (a.k.a. non-clearance engine). If the Golf 1.8T timing belt fails, the timing belt system that links the cylinder head, camshafts, and crankshaft no longer run in sync. Close tolerance engine designs allow for the cylinder head valves to hit the top side of the pistons.
How to replace a water pump on a Volkswagen Golf GTI?
Begin by screwing the threaded portion of the stud into the tensioner mount on the engine block. There is a small threaded hole in the mount that the stud will thread into. Next install the washer and nut on the stud so that they are between the cut out in the tensioner lever/bar.
Where to put timing belt on Volkswagen GTI Mk IV?
When installing the new belt place it on the cam sprocket first with the sprocket set at TDC. It is a good idea to zip tie the belt in place on the sprocket while installing the belt on the crank sprocket.
Can a DIY mechanic replace a VW Golf?
It is not a quick or easy job, but can be done by a DIY mechanic if you take your time, have the right tools and follow the instructions. This job can take a while for a novice, so make sure you have the car in a secure and weather safe area before you start.