How to replace a front wheel drive steering shaft?
The TSB involves re-greasing the telescoping intermediate steering shaft to cure the noise. In this video, the intermediate steering shaft was replaced with a used one on a 2006 Toyota Sienna front wheel drive. Hammer, (although I recommend an air hammer!) https://www.linkedin.com/company/spee… https://www.youtube.com/subscription_… Loading…
Where can I buy parts for a broken steering column?
Our specialty is knowing what you might need and providing hard-to-find steering column parts for damaged or broken steering columns. With our full “STEERING COLUMN PARTS” inventory of the most commonly needed items on domestic vehicles, we make it easy for you to buy exactly what you need.
How many sets of instructions are there for replacing a steering column?
We have over 60 sets of STEP-BY-STEP instructions to help you repair any problem you might have with yoursteering column. Damaged steering columns from wear and tear or those just needing some special attention after years of service can be restored to fully functioning condition.
How do you replace a coupler on a steering shaft?
1) Mark position of old coupler on steering gear shaft and steering shaft with white out amd make sure the wheels are straight ahead, bolts heads should be facing up. 2) Soak coupler bolts for three days with PB Blaster (penetrating oil). 5) get 1/4 inch drill bit and drill extension. Drill deep into cap head but not all the way thru.
How to replace the steering coupler on a 380SL?
1) Disconnect Battery, remove clip carefully at bottom of gas pedal and slide petal down off accelerator rod. Remove lower panel. 3) Twist and pull boot up the steering tube carefully (relay above boot) while pushing the accelerator rod toward passenger side. 5) carefully remove horn pad on steering wheel.
How to replace Allen bolt on steering wheel?
Use 2 foot pipe or very large wrench for leverage. Hold wheel with hand / do not use the steering wheel lock to hold wheel while breaking allen bolt loose. It takes a good amount of force. Use NEW allen wrench. You do not want to strip this head. Remove steering wheel.
The TSB involves re-greasing the telescoping intermediate steering shaft to cure the noise. In this video, the intermediate steering shaft was replaced with a used one on a 2006 Toyota Sienna front wheel drive. Hammer, (although I recommend an air hammer!) https://www.linkedin.com/company/spee… https://www.youtube.com/subscription_… Loading…
Where is the intermediate steering shaft located on a car?
The intermediate steering shaft connects the steering column underneath the dashboard to the steering rack pinion underneath the vehicle. It is comprised of a telescoping shaft with two universal joints to account for a steering column tilt angle and collapsibility.
How are the shafts aligned on a GM tilt steering column?
Insert the main shaft “C” into the ball at a ninety degree angle, there’s a slot in the stub shaft for this, then straighten the two shafts until they are aligned, thus locking the shafts together at the ball joint. There should be strong friction as the shafts are aligned and no play when you are done.
How to replace a steering shaft on a Toyota Sienna?
https://static.nhtsa.gov/odi/tsbs/201… The TSB involves re-greasing the telescoping intermediate steering shaft to cure the noise. In this video, the intermediate steering shaft was replaced with a used one on a 2006 Toyota Sienna front wheel drive. Hammer, (although I recommend an air hammer!) https://www.linkedin.com/company/spee…