How to repair a 4wd front axle disconnect?
Lift front of vehicle and properly stabilize Remove passenger front wheel Un-clip wheel sensor wire (3 places) Remove brake line holder from knuckle Remove CV axle nut (35 mm) Tap end of CV axle to remove from wheel bearing Remove (or cut off) end link Remove upper ball joint from upper control arm Remove nuts from upper strut mount
How do you remove a front axle on a s4wd?
Excessive play in the axle shaft connection inside the axle disconnect. 1. Raise & support the vehicle properly, remove the passenger front wheel, splash shield, & then remove the passenger front CV axle. 2. On S4WD models, remove the electric axle actuator from the axle disconnect assembly by removing the 2 bolts and electrical connector.
How do you remove a front CV axle?
Raise & support the vehicle properly, remove the passenger front wheel, splash shield, & then remove the passenger front CV axle. 2. On S4WD models, remove the electric axle actuator from the axle disconnect assembly by removing the 2 bolts and electrical connector.
What’s the best way to remove axle bearings?
When fully assembled, this is what the break pads normally make contact with. It will be bolted on, but just remove the bolts and pull it off. For some, a hammer may need to be used to break the rotor loose. Remove the axle bearings using the bearing replacement/removal tool. This will separate the bearing and the axle by pushing them apart.
Lift front of vehicle and properly stabilize Remove passenger front wheel Un-clip wheel sensor wire (3 places) Remove brake line holder from knuckle Remove CV axle nut (35 mm) Tap end of CV axle to remove from wheel bearing Remove (or cut off) end link Remove upper ball joint from upper control arm Remove nuts from upper strut mount
How do you remove cv shaft from front axle?
Use a drift against the back of the CV tripod housing and hammer to remove from disconnect (you may need a large sledge hammer) At this point, you have removed the CV shaft from the disconnect, however if you haven’t don’t worry. When I went to hammer out my CV shaft, the shaft would only rattle around due to the crushed bearings.
Where is the front axle disconnect located on a Honda Accord?
Unit 56, above, is known as the front axle 4WD disconnect. It resides on the passenger side of the oil pan, opposite of the front differential. The disconnect allows the front left and right wheels to spin independently of each other, and allows the front prop-shaft to remain still while in 2WD mode.
How do you remove the front wheel on a zzr1200?
Once the front wheel is up, remove the axle from the right and observe how everything came off. Make sure you pay attention to the speedometer housing. One of the things I do, is take off the speedometer collar that sits on the wheel itself. There is a snap ring that holds it against the wheel.