How to remove timing cover on Jaguar XJ6?

Disconnect the two large diameter water hoses and remove the pump and top hose to a place of safety. The preliminaries completed, you can now start removing the timing cover which is held on by a total of 19 bolts – see drawing – note that three of these holding the water pump in place are already removed.

Is it easy to repair a Jaguar timing chain?

Firstly, Jaguars were not designed to be easy to repair? discover why the apparently simple task of checking the timing chains is far from simple. Do use 6 point sockets to start the 10mm bolts – the bolts are often in so tight the standard 12 point sockets started to slip on the heads. The preliminaries

What kind of transmission does a Jaguar XJ6 have?

Jaguar XJ6 Service and Repair Manual 3261 Jaguar XJ6 Models covered Jaguar XJ6 models with 3.2 litre (3239 cc), 3.6 litre (3590 cc) & 4.0 litre (3980 cc) six-cylinder in-line dohc petrol engines and automatic transmission

Where are the timing marks on a XKE engine?

For the early XKE engines the stationary timing mark is at the very bottom of the crank shaft. I understand that for later engines it is up on the sides, at the 10:30 or 2:30 position, depending on how you look at it. It’s a flat piece of metal that extends out over the crankshaft pulley. On the pulley, you need to identify the timing marks.

How is the chain on a Jaguar XJ6?

The damper on the tension (right) side of the chain is straight and fixed. The chain is slack and has dropped in the picture, take care NOT TO TURN THE ENGINE in case it jumps a sprocket. Looked at end-on you can clearly see the amount of wear on this tensioner. The new tensioner looked much better! this shows both secondary guides.

What is the pivotted guide on a Jaguar XJ6?

Top left is the pivotted guide which maintains the tension on the chain when the chain tensioner is in place. The damper on the tension (right) side of the chain is straight and fixed. The chain is slack and has dropped in the picture, take care NOT TO TURN THE ENGINE in case it jumps a sprocket.

Where is the spacer on a Jaguar XJ6?

This will lead to gnashing of teeth and the need to take the timing cover off again. Push the spacer back onto the crankshaft and locate the woodruffe key in its slot.

What’s the low coolant level on a 1998 XJ?

1997 MY-ON XK8 Range 1998 MY-ON V8 XJ Series 001001-ON 812256-ON MODEL VIN Low Coolant Level – Warning Lamp Illuminated Issue: When a new vehicle is factory-filled with antifreeze solution, small pockets of air may remain trapped in the cooling system.

Where is the transmission on a Jaguar XJ6?

Transmissions are a four-speed automatic equipped with a lock-up torque converter. The transmission is mounted to the back of the engine, and power is transmitted to the fully independent rear axle through a two-piece propshaft.

What kind of engine does a Jaguar XJ6 have?

Models covered Jaguar XJ6 models with 3.2 litre (3239 cc), 3.6 litre (3590 cc) & 4.0 litre (3980 cc) six-cylinder in-line dohc petrol engines and automatic transmission

Can a top chain tensioner be replaced on a Jaguars?

You MIGHT get away with just replacing the top chain tensioner which can be replaced without excessive dismantling. Firstly, Jaguars were not designed to be easy to repair? discover why the apparently simple task of checking the timing chains is far from simple.

Can you hook behind the timing chain on a Jaguar?

You can’t hook behind it because it is flush to the sprocket. Two alternatives – either get it off somehow; or remove the timing cover!!!

How do you remove a timing belt cover?

On most timing chain cars and many timing belt cars, the water pump has to come off to get access to all of the bolts or to get enough clearance to get the cover off. Remove the bolts holding it down and gently pry it off. Step 6: Remove the drive pulley.

Navigation