How to remove the thermostat housing on a Toyota Camry?
A 10 mm box wrench can be used on the top nut, but there is very little twisting room for the lower nut unless the oil filter is removed. 4. Remove the thermostat housing with a strong tugging or pulling motion. Approximately 1/2 gallon of coolant will leak out when the housing is removed.
What makes a Toyota thermostat an OEM part?
OEM thermostats are made to meet Toyota’s factory standards for performance. OEM thermostats are manufactured to last as long as the original. When it comes time to buy your OEM Toyota parts, turn to Olathe Toyota Parts Center.
What to do if your Toyota Camry overheats?
Make sure that you don’t wind up on the side of the road with an overheated engine by installing a replacement thermostat for Toyota Camry. Faulty thermostats prevent coolant from reaching your engine block, which leads to overheating.
How to replace the temperature sensor on a Toyota Camry?
Reverse the above steps for installation, refill the radiator with new fluid, start engine until warmed up and recheck fluid levels after cool down. Allowing the engine to idle for 1/2 hour with the radiator cap off can help remove air pockets. 2. Replacing the Temperature Sensor
What causes a Toyota Camry to stall at traffic stops?
Most commonly, a malfunction of this sensor results in over-enriching the air/fuel mixture, causing the engine to stall at traffic stops. And an engine will run cooler with an enriched air/fuel mixture. This sensor has an O-ring, so ask for the O-ring when you buy a new sensor.
Is it OK to drive a 1999 Toyota Camry?
I have 1999 Toyota Camry LE 2.2 L, when I drive its temperature sensor gauge in car shows at C or close to C. Car heats up and show at 1/6 of range on needle above C at idle after drive (gauge moves). What should be course of action? Is it ok to drive?
How to keep coolant from leaking out of the thermostat?
Use an open-end or box wrench to spin off the sensor. Once the sensor is removed, coolant will start leaking out. To keep all the coolant from draining out, quickly screw in the new sensor by hand. Don’t forget the O-ring attached to the sensor. 6. Reverse the above steps for re-assembly, and replenish the leaked-out coolant.