How to pass car inspection after changing battery?
4) get into the car, take it for a drive of various speeds, starting at 25 mph for about 1-5 miles….as time goes on, increase your speed to the LEGAL SPEED LIMITS on your roads…DO NOT SPEED. If you can, THEN get on the highway, and go the SPEED LIMIT for about 5-10 miles….
What should I do if my car battery has been disconnected?
Herculean strength isn’t necessary, but the cables should be snug and not move around or come off of the battery posts. You can also check your owner’s manual for any procedures or drive cycles you can perform to “teach” the car functions it may have lost while the battery was disconnected.
Are there any problems after replacing a battery?
RepairPal looks into two specific problems many car owners can experience after replacing their batteries. Late model vehicles have many computerized systems; in most cases, each system is under the basic control of its own computer (module).
Why is my car not starting after replacing the battery?
If none of these work and your car still isn’t starting, it could come down underlying issues with your vehicle’s starter, ignition switch, immobilizer system, or the neutral safety switch. The engine computer has a basic idle speed control setting for when the engine is new.
Can a Toyota drive cycle complete the catalyst monitor?
The catalyst monitor on many Toyota vehicles can be difficult to complete. That’s why it’s important to follow the Toyota recommended drive cycle after performing actions that are known to clear your Toyota’s computer memory.
What happens when you disconnect the battery on a car?
The best way to do this would be with a scanner, but if you don’t have one, disconnecting the battery will do the trick on many vehicles. However, disconnecting the battery will not only erase diagnostic trouble codes but also erase drivability, security and radio codes in many vehicles.
When do I need to get my Toyota Camry inspected?
When the car goes to inspection, their scanner can tell when the last time in miles when the codes were cleared, and tell you to come back if the required miles have not ben driven. So you need to getter fixed. 4 people found this helpful. I just today took my 2002 Subaru in for smog test.
Why did my car fail the emission test?
A couple of weeks ago I changed my battery but had not driven the car much before taking it to inspection and promptly failed the emission test because the evaporative, catalyst and O2 systems were not ready. Since then I drove about 100 miles with a mixture of local roads and highway over a 4 day period.
How does a pinpoint pressure test work on a Camry?
Pinpoint pressure test procedure is adopted by pressurizing the fresh air line that runs from the canister pump module to the air filler neck. For details, see the 2007 Camry Repair Manual (Pub. No. RM0250U).
When does an OBD II car not pass inspection?
“Generally, OBD II vehicles from model year 1996 to model year 2000, inclusive, will fail if 3 or more monitors are set as “Not Ready;” while model year 2001 and newer vehicles will fail when 2 or more monitors are reported as “Not Ready.””