How to fix distributor on 97 Chevy k1500?
Just put a thin layer of silicone around the edge when replacing and boom problem fixed. Tried silicone, have replaced 5 times, just broke down again during rain storm. She just doesn’t like the rain. So putting in aluminum distributor will fix. Will see.
How to repair GMC CK Series truck HVAC unit?
Use paper clips or wires to jumper across the switch connectors on the wire harness. Key on engine off, compressor clutch should “click”. If no click, check the wiring harness for open wires, functioning high pressure switch, and correct voltages. TESTING LOW PRESSURE SWITCH. With the truck running, A/C turned on.
What’s the name of the Chevy C / K 1500?
Chevrolet C/K 1500 Questions – 97 chevy k1500 5.7 vortec is burning distributor cap and rotor about e… – CarGurus every month or two i am burning up distributor cap and rotor.
How is the recirc door closed on a GMC CK?
The functions of the Recirc door are controlled by detent switches that are part of the Blend and Mode dials, and the AC Switch. When Switched +12V is present the Resirc door is closed by one of the following two conditions: ( (Recirc switch depressed) or (not Defog, plus Max AC, plus AC on)).
Use paper clips or wires to jumper across the switch connectors on the wire harness. Key on engine off, compressor clutch should “click”. If no click, check the wiring harness for open wires, functioning high pressure switch, and correct voltages. TESTING LOW PRESSURE SWITCH. With the truck running, A/C turned on.
What is the temperature control on a GMC CK truck?
Power is routed back out to Pin 7 through a 3.8 ohm resistor and the Max AC switch, but on a 1500 truck Pin 7 is not used. The Blend (temperature) door control is powered directly from +12V via Pin 5.
The functions of the Recirc door are controlled by detent switches that are part of the Blend and Mode dials, and the AC Switch. When Switched +12V is present the Resirc door is closed by one of the following two conditions: ( (Recirc switch depressed) or (not Defog, plus Max AC, plus AC on)).
Why is there a recall on my GMC?
A safety/non-compliance recall is initiated by GM and communicated to the National Highway Traffic & Safety Administration to remedy a safety-related defect, or a non-compliance to a federal motor vehicle safety standard. For emission-related recalls, GM works with the U.S. Environmental Protection Agency and the California Air Resources Board.