How to disable a 2002 Ford Explorer car alarm?
If you want to disable the alarm yourself – which is not advisable because it severely hampers your vehicle’s security – then there should be a button located on the vehicle to do this. How to disable a 2002 Ford Explorer car alarm. You’ll have to locate what is known as the valet/override button. It will be a small spring-loaded, hidden button.
How can I override the car alarm system?
When you have found this button, turn on your ignition. Then press and hold this button until the alarm beeps once. This should now override the car alarm system, and the only security system which will remain in place is the keyless entry part (if your car has one).
Where is the factory alarm on my car?
Find the alarm system. If you have a factory car alarm, check in your owner’s manual as a guide. The alarm system is usually under the hood near the steering wheel. If you have an after-market car alarm, it may be installed in any part of the car, but companies usually install them under the steering wheel. Disconnect wires.
How do you reset an aftermarket car alarm?
Almost all alarms, both factory installed and aftermarket systems, will shut off and reset when the car is started. Step 3: Use your key to unlock the driver’s door. This will usually turn off and reset the alarm. In the event that the driver’s side door is already unlocked, lock the door and then unlock it again. Step 4: Pull the fuse.
How do you turn on an axiom alarm?
Press and Hold the “B” key or 4 & 6 keys together for over 3 seconds to activate EMERGENCY ALARM. ARMED 1, ARMED 2, & READY lights will start flashing with a buzzer pulsing. NOTE: This alarm will not time out and must be cleared by entering a valid password. This is an alarm to call Security silently.
How does the door chime work on Axiom 3?
To enable a door-knock sound whenever a zone is open, press and hold the number key button corresponding to the desired zone on the keypad for approximately 3 seconds. The door chime is enabled if you hear a KNOCK sound and if you hear an ACKNOWLEDGE sound, the door chime is disabled. CANCELING AN ALARM. After an alarm, the panel audio sounds.
What do you need to know about the axiom III safesuite?
New Residents! AXIOMIII SAFESUITE system has been specifically designed for Condominium living to allow for more flexibility on off-site notification and onsite interaction with the buildings common area, while maintaining individual suite control. The Axiom III Safesuite is an 8-zone, fully supervised alarm control panel.
How to bypass a zone on an axiom 3?
Arming the panel in INSTANT mode arms panel with no entry/exit delay and disables interior zones (e.g. motion detectors). Arming the panel while a zone is open. FORCED ARM automatically bypasses an open zone, but the zone becomes part of the system once closed. Enter your four digit user code, press 33 and #. BYPASS MODE (Also known as SHUNT MODE.)