How to configure MY BMW headlight settings?
– YouTube BMW UK | How do I configure my BMW headlight settings? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. BMW Technology.
How to adjust the headlight on a Harley Davidson?
How to adjust Harley-Davidson™ LED headlight. DIY, Harley-Davidson™ Heritage Softtail® – YouTube
Where do you Put Your Headlights on the aiming wall?
The front of your headlights should be 25 feet from the aiming wall chart you’ve created. Turn on your lights: Turn off your garage lights or any other light source and turn on your vehicle’s headlights to compare their alignment to the guide. If you’re adjusting your headlights outside, you’ll need to do this work at night.
How do you adjust the beam of a headlight?
Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.
Where are the adjustment screws on a headlight?
The first thing you need to do is locate the adjustment screws on your vehicle. In many cases, it will be necessary to remove the trim ring from the headlight. Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner’s manual.
How to adjust your headlights when aligning your lights?
In order to make sure the car is properly leveled when aligning the lights make sure all the tires are properly inflated, the vehicle has at least a half tank of fuel and there is someone sitting in the driver’s seat. This will ensure that the vehicle is leveled and is reflects common driving conditions when the measurements are taken.
The front of your headlights should be 25 feet from the aiming wall chart you’ve created. Turn on your lights: Turn off your garage lights or any other light source and turn on your vehicle’s headlights to compare their alignment to the guide. If you’re adjusting your headlights outside, you’ll need to do this work at night.
How do you remove a headlight from a car?
Use a tape measure to make sure you are the proper distance away from the wall. Turn off the headlights. Remove the trim ring from around the headlights and locate the adjusting screws. These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights.