How to check for pulse on fuel injector?
First grab that multimeter. T-pin into the “power” side of the injector with the key in the run position. You should have battery voltage. If you don’t, grab a wiring diagram and follow those wires back, continually checking for power the whole way.
Why is my fuel injector # 2 cylinder not getting fuel?
No Pulse I hooked a stethoscope to the injector #2 and it has no pulse. All the injectors are ticking perfectly fine. I switched injectors to stock and have 8 set of these injectors and no matter which injector I use, the #2 cylinder isnt getting fuel. The engine studders and has terrible rough idle at like 550rpm.
What kind of fuel injector wire do I Need?
The engine studders and has terrible rough idle at like 550rpm. I did a compression check, the engine was cold and it was 120 across the board. The engine has 1500 miles on a 6 bolt swap. (8:3:1 blocked decked) My fuel management is safc, 450inj, afpr aeromotive 1:1, 255lfp. The car was running fine until I swapped out turbo and injectors.
Why is the number 2 injector not pulsed?
If you don’t get it, the injector isn’t being pulsed. Now, since it’s only the number 2 injector, it shouldn’t be the injector driver in the ecu. Look at wiring diagrams again and trace the injectors back to the ecu, checking for voltage just like you did before. Most likely you have an open somewhere. Click to expand…
First grab that multimeter. T-pin into the “power” side of the injector with the key in the run position. You should have battery voltage. If you don’t, grab a wiring diagram and follow those wires back, continually checking for power the whole way.
If you don’t get it, the injector isn’t being pulsed. Now, since it’s only the number 2 injector, it shouldn’t be the injector driver in the ecu. Look at wiring diagrams again and trace the injectors back to the ecu, checking for voltage just like you did before. Most likely you have an open somewhere. Click to expand…
No Pulse I hooked a stethoscope to the injector #2 and it has no pulse. All the injectors are ticking perfectly fine. I switched injectors to stock and have 8 set of these injectors and no matter which injector I use, the #2 cylinder isnt getting fuel. The engine studders and has terrible rough idle at like 550rpm.
Can a car injector be pulsed on a multimeter?
With the car running, it may be hard to see because multimeters are so slow, but you should get a pulsed battery voltage. It will probably just show up as a constant voltage on the multimeter however. If you don’t get it, the injector isn’t being pulsed. Now, since it’s only the number 2 injector, it shouldn’t be the injector driver in the ecu.