How to change battery on Honda Metropolitan scooter?
Step 1 Park your scooter on level ground and engage the center stand for support. Turn the engine off. Open your seat to access the maintenance lid. Pull back the two tabs to release the maintenance lid, and then set it aside. Loosen the nut to remove the negative battery cable, and then remove the positive battery cable.
What kind of engine does the Honda Metropolitan have?
Then look no further than the 2022 Honda Metropolitan. It’s the European-style scooter engineered to embody American practicality. The nifty and thrifty design starts with a reliable four-stroke engine, with a no-shift automatic transmission. Complete with an electric starter and underseat storage to help you on the go.
What to do if your scooter won’t turn over?
Check your owner’s manual to make sure that you are doing all you need to to complete the electrical circuit which enables it to start. If the scooter doesn’t turn over when you’ve done all the required operations, there’s an electrical problem with the battery. Make sure the battery is charged.
Where is the Kill Switch on an electric scooter?
Most scooters have four things that need to be done before they can be started with the electric starter: The kill switch (usually near the right grip) has to be in the “on” position The rear (left) brake lever has to be squeezed. The starter button must be pressed. Some scooters may have other interlocks on the front brake or the center stand.
How do you take the kickstand off a Honda Metropolitan?
Take your Metropolitan’s kickstand off. The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand. Unscrew the six bolts holding the metal lid of your variator case in place and take the lid off of your scooter.
Where is the washer on a Honda Metropolitan scooter?
Honda Metropolitan scooters, like most scooters, are restricted by a small washer that can be found on the front pulley road inside the scooter’s variator system.
How to troubleshoot Honda Metropolitan CHF50 ignition system?
Page 271 IGNITION SYSTEM Disconnect the throttle position sensor 3P connec- YELLOW/RED YELLOW/BLUE tor. Check the 3P connector for loose contact or cor- roded terminals. Measure the resistance between the Yellow/red and Yellow/blue wire terminals of the sensor side con- nector.
Honda Metropolitan scooters, like most scooters, are restricted by a small washer that can be found on the front pulley road inside the scooter’s variator system.
Take your Metropolitan’s kickstand off. The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand. Unscrew the six bolts holding the metal lid of your variator case in place and take the lid off of your scooter.
Can a Honda Metropolitan scooter be run over 30 mph?
Though it will not affect the engine size and output capability, removing the restricting washer could allow your Metropolitan to travel over 30 mph, which is illegal in some states. You will need to either operate your Metropolitan under 30 mph or re-register it as a larger motorcycle.
How do you take the kickstand off a Honda variator?
The kickstand is secured with a small pin that must be loosened with a socket wrench before you can pull it out and remove the kickstand. Unscrew the six bolts holding the metal lid of your variator case in place and take the lid off of your scooter.