How to change a distributor on a 94 Camry?
How to Replace a 1994 Toyota Camry’s Distributor
- Unscrew the two mounting screws that hold the distributor cap in place.
- Disconnect the center wire that is routed to the distributor from the ignition coil.
- Unplug the wiring connector that hooks the main wiring harness to the side of the distributor.
Does a 1996 Camry have a distributor?
The Toyota Camry used distributors in its engines up to 1996. If you have engines from those years that are 2.0L, 2.2L, 2.5L and 3.0L, then your engine has a distributor. If you’re handy with basic tools, then you can replace the distributor.
How can you tell if your distributor cap is bad?
Check the Distributer Cap Often the distributor cap is suspect. The distributor cap should be inspected carefully to see how the sparks are arcing. The internal and external surface of the cap should be clean. No erosion should be on the surface and the firing points should be free of rust or corrosion.
When to replace the distributor in a Toyota Camry?
The Toyota Camry used distributors in its engines up to 1996. If you have engines from those years that are 2.0L, 2.2L, 2.5L and 3.0L, then your engine has a distributor. If you’re handy with basic tools, then you can replace the distributor.
Why does my 1994 Toyota Camry stop running?
The 1994 Toyota Camry distributor is a stand-alone design. That means all the spark is triggered by the distributor and not the car computer. If the car stops running because there is no spark, and there is battery power to the distributor, the distributor is likely defective. This is not an uncommon problem.
Where is the timing mark on a Toyota Camry?
Set the No. 1 piston at the Top Dead Center (TDC) mark by turning the crankshaft bolt clockwise; you’ll find it in the pulley near the bottom of the engine. Use a long-handled ratchet (breaker bar) to turn the engine. The timing mark on the crankshaft pulley must line up with the 0 mark on the No. 1 indicator on the timing belt cover.
How do you replace a distributor on a car?
Experienced home mechanics can replace the distributor in a few steps. Unscrew the two mounting screws that hold the distributor cap in place. The screws will not fall out, so alternate the loosening process, back and forth between the two screws, until the cap is free.