How often do you change transmission oil on a Sportster?
Sportster Transmission Oil Change After the 1000 mile check-up, the Sportster transmission oil is changed every 10,000 miles. Changing the transmission fluid is a straight forward procedure, and for about $10.00 in parts, is a much cheaper solution than bringing it to the dealer. Ride the bike to heat up the transmission oil prior to draining.
What kind of transmission fluid do you use on a Sportster?
After doing some more reading on the Redline website, they say NOT to use their Transmission fluid for Sportsters, but to use their Redline Lightweight W/Shockproof. That arrived today and I took the Redline V-T Trans fluid out and put that in.
How to check the transmission on a Harley Davidson Sportster?
Hold the clutch lever in and place the transmission in first gear with the bike at a standstill. There should be no engine power transferring to the rear wheel. Figure 1. Sportster clutch lever and cable. The fluid level is easily checked through the derby cover or dipstick on some models.
What kind of oil do you put in a Sportster?
Some will chime in for Amsoil as well. HD formula+, Spectro Chaincase or even the above oils for the Tranny. Gear oil can also be used if its GL1 rated NOT gl5. Because the Sportster’s primary and transmission share a common sump, be careful what you put in there.
How to change transmission fluid on a Harley Davidson Sportster?
Harley Davidson Sportster: How to Change Transmission Fluid. The transmission fluid reduces friction and heat inside your transmission. Any wear from metal or clutch material becomes mixed with the fluid and reduces its ability to lubricate. When this occurs, transmission wear will accelerate until shifting problems develop.
How often do you change the oil on a Sportster?
Sportster Transmission Oil Change. After the 1000 mile check-up, the Sportster transmission oil is changed every 10,000 miles. Changing the transmission fluid is a straight forward procedure, and for about $10.00 in parts, is a much cheaper solution than bringing it to the dealer.
Where to put primary lubricant in Sportster transmission?
Using a funnel, pour 32 ounces (one bottle) of Harley Davidson Transmission and Primary Chaincase Lubricant into the primary chain inspection hole. According to the Sportster maintenance book, the fluid level should not go above the bottom of the clutch diaphragm spring.
What’s the correct torque for a Sportster transmission?
The correct torque specification is 14 – 21 ft-lbs (168 – 252 in-lbs). Insert the nozzle of a funnel into the primary chain inspection hole. Pouring slowly, pour approximately 1 qt of oil into the transmission. As you pour, watch the clutch inspection hole. Make sure that the oil level stays below the edge of the clutch inspection hole.