How often do you change the spark plugs on a Kia Rio?
Replace spark plugs (iridium coated), (Every 100,000 miles or 120 months) Rotate tires – including tire pressure and tread wear (Every 7,500 miles or 12 months) Inspect air conditioning compressor, air conditioner refrigerant and performance (if equipped)
Where can I get new spark plugs for my Kia?
Factory-trained Kia experts will assess the condition of your vehicle, including the spark plugs, to find the problem and recommend a long-term fix. Here in Olympia and just minutes from Lacey, you’ll find the Hanson Kia service department at 2300 Carriage Loop SW, Olympia, WA 98502.
Do you need to change the spark plugs in a car?
Today, there are fewer parts under the hood of a modern car that need to be regularly adjusted. The engine control computer handles things like engine timing that once needed to be manually tweaked – but not so today. Even the spark plugs are improved from a few decades ago, and can now last more than 100,000 miles in your vehicle.
How often should I Change my Kia Rio tires?
Add fuel additive *A (Every 7,500 miles or 12 months) Rotate tires – including tire pressure and tread wear (Every 7,500 miles or 12 months) *1 lnspect “Water Pump” when replacing the drive belt or timing belt. *A If TOP TIER Detergent Gasoline is not available, one bottle of additive is recommended.
Replace spark plugs (iridium coated), (Every 100,000 miles or 120 months) Rotate tires – including tire pressure and tread wear (Every 7,500 miles or 12 months) Inspect air conditioning compressor, air conditioner refrigerant and performance (if equipped)
Factory-trained Kia experts will assess the condition of your vehicle, including the spark plugs, to find the problem and recommend a long-term fix. Here in Olympia and just minutes from Lacey, you’ll find the Hanson Kia service department at 2300 Carriage Loop SW, Olympia, WA 98502.
Where can I get additives for Kia Rio?
Additives are available from your authorized Kia dealer along with information on how to use them. Do not mix other additives. ❈ Inspect : Inspect and if necessary, adjust, correct, clean or replace.
Today, there are fewer parts under the hood of a modern car that need to be regularly adjusted. The engine control computer handles things like engine timing that once needed to be manually tweaked – but not so today. Even the spark plugs are improved from a few decades ago, and can now last more than 100,000 miles in your vehicle.
How do you change the spark plug on a Kia Sorento?
Open the hood of the 2006 KIA Sorento and remove a rubber wire from one of the spark plugs. Use the ratchet and spark-plug socket to remove that spark plug from the engine. Insert the new spark plug into the hole where the old plug was.
How do you change spark plugs on Kia Sportage?
Reconnect the battery cable after you replace all the spark plugs. Open the hood to the Kia Sportage. Do not perform this repair on a hot engine. If it is hot, allow it to cool down before going any further. Disconnect the negative terminal from the battery using a hand wrench or ratchet and socket.
Do you need to replace spark plug wires?
Damage: It’s possible for spark plug wires to be damaged. If the insulation is compromised, or there’s an internal break, you’ll need to replace your wires even if it’s not yet time.
How do you change the spark plugs on a Kia?
Tighten the ignition coil packs to 4 to 5 foot-pounds, using a torque wrench and socket. Plug the wiring harness back into the top of the coil pack. Repeat steps 3 through 7 until you replace all four spark plugs on the 2.4-liter engine, or all six plugs on the 2.7-liter engine.
Where is the spark plug Gapper on a Kia Sorento?
Insert the edge of the spark-plug gapping tool under the meal arm in the center of the one of the new spark plugs and turn the gapper until the number .038 is in the center of the metal arm. Repeat this for all other new spark plugs. Open the hood of the 2006 KIA Sorento and remove a rubber wire from one of the spark plugs.
Can you cross thread a spark plug on a Kia?
Cross threading a spark plug can damage the cylinder head. Tighten the plug to 13 to 15 foot pounds using the spark plug socket, the extension and the adjustable torque wrench. Reconnect the tension leads. Reconnect the coils and four bolts to the cylinder head cover. Reconnect the coil cover and six bolts.
What’s the best way to tighten a spark plug?
Attach a torque wrench and apply 11 foot-pounds of torque to the spark plug. Apply a thin coat of dielectric grease inside the rubber boot on the base of the coil pack and press the coil onto the spark plug until it “clicks” into place. Tighten the ignition coil packs to 4 to 5 foot-pounds, using a torque wrench and socket.