How much play should a torque converter have?
Converter must be free to move a minimum of 1/8″, but not more than 3/16″. If converter has no end-play, converter was installed improperly. Remove transmission and correct problem.
Do you add transmission fluid torque converter?
When installing the converter onto the transmission, please pour approximately one quart of ATF (automatic transmission fluid) into the converter before installing into the transmission. You should experience two distinct drops of the converter into the transmission before it is all of the way in.
Will torque converter fill itself?
Unfortunately, many torque converters can only be refilled while the transmission is already out of the vehicle. However, you can refill some if they are equipped with either a lock-up torque converter or torque converter drain plug without removing them from the vehicle.
Do you have to fill a new torque converter before installing?
When did the 4R70W torque converter stop coming out?
The F150 trannys have a one (1) inch longer output shaft and extension housing. This necessitates a shorter driveshaft and probably modifications to the crossmember as well. 3. Starting about 2002 (and possibly earlier in some cases), the 4R70W stopped coming with output shafts that have the speedometer-drive-gear splines.
How does a torque converter work in a C4 transmission?
This is how the torque converter interacts with your C4 or C6 transmission. Fluid under pressure through the stator drives the turbine and transmission input shaft. Stator support carries the torque converter and is also an integral part of the transmission’s front pump.
What are the installation instructions for a torque converter?
Torque Converter Installation Instructions. After bell housing bolts are tight, check free movement of converter. It should have 1/16 to 1/8″ (ON GM ONLY) of clearance between pads on converter and flex plate. If you have more than 1/16 to 1/8″, install equal thickness washers to reduce clearance to 1/16 to 1/8″ (ON GM ONLY).
How many horsepower does a 2001 4R70W have?
I just got a great deal on 2001 4R70W from a 3.8 car. It came with the starter, torque converter, wiring, etc. I need some opinions on the torque converter. My motor, when put back together, will likely be in the 400-450 flywheel HP range. It is a daily driver street type of car (no racing).