How much is an alternator for a 1996 Honda Civic?
We currently carry 9 Alternator products to choose from for your 1996 Honda Civic, and our inventory prices range from as little as $98.99 up to $280.44.
Where do you change the alternator on a Honda Civic?
Replacing your alternator does not require any specialty tools. It can be a lengthy job, and also requires a lot of work inside the engine bay. So if you don’t feel comfortable being underneath the car, then it is recommended having this done at a repair shop. Locate the appropriate spot underneath the car to jack up your Civic.
How to test a Honda alternator without removing it?
The alternator in your Honda provides the electrical power to your vehicle after the engine starts. Testing the charging system of the Honda presents some difficulties, but this project is still within the abilities of a well-equipped weekend mechanic. Set the controls on your digital volt/ohm meter to the “Volt D/C” position.
How do you remove an axle from a Honda Civic?
Attach a 17mm socket and ratchet on one end, and a 17mm wrench on the other. Hold wrench in place while the ratchet undoes the bolt. Once bolt is loose, use the hammer to get it off. Figure 7. As you can see, the axle goes right through the strut. Hence the need to remove it. With everything out of the way, the axle is ready to be pulled out.
Where is the B Terminal on a Honda Civic?
Remove the B terminal by removing the bolt located to the right of the 4P connector. Loosen the adjusting bolt located above the belt. Loosen the upper bracket support. Remove splash shield underneath the car to access alternator from below if necessary. Figure 2. Unclip the green 4P connector. Figure 3. Remove the alternator adjusting bolt.
Replacing your alternator does not require any specialty tools. It can be a lengthy job, and also requires a lot of work inside the engine bay. So if you don’t feel comfortable being underneath the car, then it is recommended having this done at a repair shop. Locate the appropriate spot underneath the car to jack up your Civic.
How to change the plugs on a Honda Civic?
Cut out the old plug, strip the wires, solder them to the new connector, and heat-shrink the connection. (Related Discussion: Honda Electrical Connectors – Honda-Tech.com)
Remove the B terminal by removing the bolt located to the right of the 4P connector. Loosen the adjusting bolt located above the belt. Loosen the upper bracket support. Remove splash shield underneath the car to access alternator from below if necessary. Figure 2. Unclip the green 4P connector. Figure 3. Remove the alternator adjusting bolt.
Where are the electrical wires on a Honda Civic?
There are several wires, all of which are bundled together in a wire loom and electrical tape. Specific areas, such as the fuel injector clips, have plastic pieces that properly route the wires to its proper location. The alternator wire also has a plastic tube that routes the wire’s power over the valve cover.