How much is an a C blower motor?
An HVAC blower motor replacement costs an average of $450 but anywhere from $150 to $2,000 to replace. It doesn’t matter if you have a gas furnace, electric or heat pump, they all use an air handler blower motor to push the air throughout your home’s ducts.
How to replace the blower motor assembly on a Honda Accord?
Before replacing your blower motor assembly, check the fuse to make sure it hasn’t blown out. Your owner’s manual will have information about which fuse controls the blower motor assembly.
Where is the heater duct on a Honda Accord?
The heater duct is located on the left side of the blower motor assembly. Figure 2. Remove self-taping screws holding heater duct in place. Remove the passenger’s side floor mat. Turn over the passenger’s side carpet, and pull it back as far as you can without tearing it.
Why does my Honda Accord not light up?
1999 honda accord: ac control head will not light..blower..fuses… I have a 1999 honda… I have a 1999 honda accord the ac control head will not light up or work when you push the buttons.I have replaced the control but got the same problem.the blower switch is the only thing that works.have checked the fuses all are ok.
How do you remove a heater from a blower?
Set aside the cover. Unplug the plug on the top left of the blower motor assembly. Use the Phillips screwdriver or 10mm deep socket ratchet and extension to remove the metal band holding the blower assembly to the heater assembly. This connection is on the left side of the blower assembly. Set aside the metal band.
Before replacing your blower motor assembly, check the fuse to make sure it hasn’t blown out. Your owner’s manual will have information about which fuse controls the blower motor assembly.
The heater duct is located on the left side of the blower motor assembly. Figure 2. Remove self-taping screws holding heater duct in place. Remove the passenger’s side floor mat. Turn over the passenger’s side carpet, and pull it back as far as you can without tearing it.
Set aside the cover. Unplug the plug on the top left of the blower motor assembly. Use the Phillips screwdriver or 10mm deep socket ratchet and extension to remove the metal band holding the blower assembly to the heater assembly. This connection is on the left side of the blower assembly. Set aside the metal band.
How do you remove the ECU from a blower?
Use the 10mm deep docket ratchet and extension to remove the three nuts holding the ECU to the bracket, and then unplug the ECU. Use the Phillips screwdriver to remove the two screws under the cover on the bottom of the blower.