How much is a valve cover gasket for a 2004 Nissan Maxima?
2004 Nissan/Datsun Maxima Valve Cover Gasket – from $13.99+ | AutoZone.com.
How much is a valve cover gasket for a Nissan Maxima?
The average cost for a Nissan Maxima valve cover gasket replacement is between $108 and $130. Labor costs are estimated between $87 and $109 while parts are priced at $21.
Do you need to replace valve covers on a Nissan Frontier?
I would at least get the gaskets for the VTC actuators, which have to be removed to remove the valve covers. The gaskets on the upper plenum are silicone, so are technically “re-usable,” but if they have 100,000 mile plus, I would replace them as they do tend to flatten out over time.
Why is the gasket on my Nissan Frontier discolored?
My theory is that the majority of oil pools in that area and gets hot, therefore causing the discoloration. Others have said that the valve cover bolts do not have to be very tight and they are right. I tightened mine down until they felt snug, but did not over-tighten and its holding up fine.
How much does it cost to replace a gasket on a Nissan Frontier?
You think the Frontier Driver’s side replacement requires a lot of disassembly, try a early Maxima with the transverse V6’s rear VC gasket, or the spark plugs. The dealer quotes $1500 for either. I’m about to do this on my 08 Frontier.
When to replace the gasket on the upper plenum?
The gaskets on the upper plenum are silicone, so are technically “re-usable,” but if they have 100,000 mile plus, I would replace them as they do tend to flatten out over time. It’s also a good time to replace the spark plugs, if do, or, install an XTP plenum spacer, if you’re considering it.
I would at least get the gaskets for the VTC actuators, which have to be removed to remove the valve covers. The gaskets on the upper plenum are silicone, so are technically “re-usable,” but if they have 100,000 mile plus, I would replace them as they do tend to flatten out over time.
My theory is that the majority of oil pools in that area and gets hot, therefore causing the discoloration. Others have said that the valve cover bolts do not have to be very tight and they are right. I tightened mine down until they felt snug, but did not over-tighten and its holding up fine.
How long does it take to replace a gasket on a Nissan Frontier?
The passenger side wasn’t too bad, I think it took me around 2.5 hours. The drivers side was horrible, there was a hose behind the plenum intake manifold that took me forever to disconnect because it was baked on from 14 years of driving and is extremely hard to reach with adult size hands.
The gaskets on the upper plenum are silicone, so are technically “re-usable,” but if they have 100,000 mile plus, I would replace them as they do tend to flatten out over time. It’s also a good time to replace the spark plugs, if do, or, install an XTP plenum spacer, if you’re considering it.