How much is a timing chain for a Saturn Outlook?
The average cost for a Saturn Outlook timing chain and gear set replacement is between $1,312 and $1,561. Labor costs are estimated between $950 and $1,199 while parts are priced at $362.
Can you change timing chain without taking engine out?
My mechanic claims that he did change the timing chain on an Acadia 2007 without pulling out the whole engine fro the car. Is that possible as to all what i read in the forum, engine has to be taken out.
When to replace timing chain on GM 3.6L VVT?
From my research this issue is a known and common major repair needed between 100K and 180K miles on vehicles with the 3.6l VVT motor. This repair is not recommended for amateur mechanics (such as myself) and would be much easier if a lift was used to drop the engine from the vehicle as demonstrated in other videos on youtube.
What is the error code for timing chain replacement?
(Playback ID: X4fUnfNC5Xo45g5w) An error occurred while retrieving sharing information. Please try again later.
Where is the hole in the timing chain?
The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear. The left camshafts will be aligned as shown when in stage two timing position. (Fig. 6)
Can a timing chain be replaced with an engine?
Published on Feb 25, 2018 Showing stretched timing chains and evidencing that the timing chain can be replaced with the engine in the vehicle on a 2012 Chevrolet Traverse 3.6 AWD Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear. The left camshafts will be aligned as shown when in stage two timing position. (Fig. 6)
Where are the timing marks on a car?
The circular timing marks on the camshafts should be aligned as shown. (Fig. 3) The painted link should be visible through the hole of the intermediate gear for the left secondary chain. Stage one primary chain alignment for the crankshaft and the left intermediate gear is shown below.
Where to install en 48383-3 timing chain?
EN 48383-3 should be installed on the right bank, or bank 1. The triangular marks should be aligned. The painted link on the right intermediate shaft should be aligned with the hole in the rear gear.